Assessments - 2, GPA: 5
(
)
)
|
Facilidade de uso
Вишневского, 14 (8432) 38-31-37/07 32. Таганрог КРИСТИ ул. Фрунзе, 45 (8634) 46-47-54 33. Ижевск Радиокомплект ул. 9-я Подлесская, 25 (3412)59-28-05 34. Барнаул Vitek - сервис ул. Попова, 68 (3852) 35-37-50 35-37-51 35. Новосибирск ООО 'Техмастер" ул. Болыиевитская, 131 (3832) 12-54-00 36. Омск Космос Космический пр-т, 97А, к.4 (3919)53-98-41 Получить информацию о других сервисных центрах Вы можете у продавца или по адресу в Интернет: ю TO ASSEMBLE 1. FIRST PUT THE UNIT UPSIDE DOWN; 2. LET THE "L" SHAPE SCREW SURROUNDING THE DOME OF THE RADIATING FLANGES OF EACH END BETWEEN THE FIRST AND THE SECOND GROUPS OF THE RADIATING FLANGES. 3. PUT TWO WHEELS AND SUPPORTING PLATE ASSEMBLIES ON THE UNIT AND INSERT THE "U" SHAPE SCREW INTO TWO HOLES OF THE SUPPORTING PLATE. 4. INSERT THE BUTTERFLYNUTS AND SCREW THEM TIGHTLY COUNTERCLOCKWISE. 5. STAND THE HEATER. TO USE 1. Insert the plug into the suitable wall outlet. 1 ) Never use the unit in place where is not even, make sure there is nothing flammable or easy deform object within 1 meter (36 inches). 2) Insert the plug after setting the thermostat to "OFF" position and setting the power selected switches to “OFF" position. 3) Do not cover the unit. 4) The heater is suitable for operation on an A.C. electricity supply having the same voltage as that show on it's rating label. 2. Press two power switches to the "ON" position then turn thermostat to the "high" position, at this moment, the unit begins to work, when the temperature rises to which you are satisfied with, slowly turn the thermostat counter clockwise until the indicating light of the key for power choice is out, and the room temperature thus can keep constant. If you want to raise or lower the room temperature, you can make another regulation: Turn the thermostat clockwise to raise the temperature and counterclockwise to lower it., or press only one shift of power switches to "ON" position. NOTES: 1 ) The pilot lamp will be on only if the temperature is below the setting value of the thermostat. 2) The room must be sealed in good condition, if not, it will not make good result because of the influx of heat. 3) The outlets of the control chamber must be kept ventilate, if not, undue move of the thermostat may occur. 3. After use, turn the power switch to the "OFF" position first, then turn the thermostat to the "OFF" position, and pull out the power supply plug. 1703.qxd 22.04.03 17:05 Page ENGLISH CLEANING AND MAINTENANCE 1) The electric heater should be cleaned regularly to wipe out the dust in the surface of flanges. As this may result the radiating efficient. 2) Disconnect electricity supply and allow radiator to cool, wipe out with a soft damp cloth. Do not use detergent or abrasives. 3) Do not scrap the surfaces of flanges with sharp hard tools, to avoid surfaces getting rusty, because of damage of the paint coat. CAUTIONS FOR OPERATION 1. Never use the unit in places where are not even or unstable. 2. Do not insert and pull out the plug with wet hand, as this may cause electrical shock. Power supply capacity should be enough. 3. The heater must only be used in the upright position. Never use when the unit is fallen over. 4. The unit should be far away with the object flammable or easy deform during uses. 5. Do not allow smashing the surface with rod or sharp hard tools, as this may cause deform and get rusty because of damage of paint coat. 6. Unit surface temperature of the flanges is high, thus do not touch it except handle, knobs. 7. Don't heat wet clothing etc. in the surface of the control chamber, as this may cause undue move of the thermostat. IMPORTANT SAFEGUARDS When using any electrical appliance, basic safety precautions should always be followed, including the following. 1. To ensure familiarity with the controls, safety features, and operation of your heater-Read all instructions before use. 2. To reduce hazard of injury due to e...