Assessments - 4, GPA: 4.5
(
)
)
|
Facilidade de uso
Алексеевская, 9 (8312) 19-41-08/10 31. Казань ТЕХНИКА ул. Вишневского, 14 (8432) 38-31-37/07 32. Таганрог КРИСТИ ул. Фрунзе, 45 (8634) 46-47-54 33. Ижевск Радиокомплект ул. 9-я Подлесская, 25 (3412)59-28-05 34. Барнаул Vitek - сервис ул. Попова, 68 (3852) 35-37-50 35-37-51 35. Новосибирск ООО 'Техмастер" ул. Болыиевитская, 131 (3832) 12-54-00 36. Омск Космос Космический пр-т, 97А, к.4 (3919)53-98-41 Получить информацию о других сервисных центрах Вы можете у продавца или по адресу в Интернет: ю ENGLISH TO ASSEMBLE 1. FIRST PUT THE UNIT UPSIDE DOWN. 2. PLACE THE WHEEL BRACKETS IN THE LAST PANEL ON EITHER END OF THE UNIT. FACE WHEELS UP TOWARDS YOU AND ATTACH BY MEANS OF U BOLTS AND WING NUTS SUPPLIED. 3. SLIDE U BOLT UNDER HEATER FRAME AND THEN ATTACH TO WHEEL BRACKETS. TO USE 1. Insert the plug into the suitable wall outlet. 1) Never use the unit in place where is not even, make sure there is nothing flammable or easy deform object within 1 meter (36 inches). 2) Insert the plug after setting the thermostat to "OFF" position and setting the power selected switches to “OFF" position. 3) Do not cover the unit. 4) The heater is suitable for operation on an A.C. electricity supply having the same voltage as that show on it's rating label. 2. When radiator is connected to the mains, turn the thermostat control knob in a clockwise direction to the MAX position and push on both switches: - Switch marked I: is for low heat - Switch marked II: is for medium heat. - Both switches depressed together: are for high heat. 3. Turbo function Press the switch to "ON" position, the fan heater begins to work separately and used as a fan heater. The temperature in the room will rise rapidly. -Q~ TEMPERATURE REGULATION When the desired room temperature has been reached, turn the thermostat control knob back, the switch pilot lights remain on, as provided for in European standarts. The temperature will remain the same, controlled by the thermostat. If the weather allows, it is possible to choose a lower heat setting by switching off one of the switches for a more economical use of electricity. CLEANING AND MAINTENANCE 1 ) The electric heater should be cleaned regularly to wipe out the dust in the surface of flanges. As this may result the radiating efficient. 2) Disconnect electricity supply and allow radiator to cool, wipe out with a soft damp cloth. Do not use detergent or abrasives. 3) Do not scrap the surfaces of flanges with sharp hard tools, to avoid surfaces getting rusty, because of damage of the paint coat. 3 1705.qxd 22.04.03 17:25 Page ENGLISH CAUTIONS FOR OPERATION 1. Never use the unit in places where are not even or unstable. 2. Do not insert and pull out the plug with wet hand, as this may cause electrical shock. Power supply capacity should be enough. 3. The heater must only be used in the upright position. Never use when the unit is fallen over. 4. The unit should be far away with the object flammable or easy deform during uses. 5. Do not allow smashing the surface with rod or sharp hard tools, as this may cause deform and get rusty because of damage of paint coat. 6. Unit surface temperature of the flanges is high, thus do not touch it except handle, knobs. 7. Don't heat wet clothing etc. in the surface of the control chamber, as this may cause undue move of the thermostat. IMPORTANT SAFEGUARDS When using any electrical appliance, basic safety precautions should always be followed, including the following. 1. To ensure familiarity with the controls, safety features, and operation of your heater-Read all instructions before use. 2. To reduce hazard of injury due to electric shock: 1) Danger of shock exists even when the appliance is switched off. ALWAYS unplug when is not use. 2) Heater should never be used under conditions where it may be immersed, or come in contact with water. Similarly do not plug in your heater if its surfaces are damp. 3) Do not op...