Assessments - 3, GPA: 4.3 ( )

Fabricante : Louisville Tin and Stove Arquivo Tamanho: 416.25 kb Arquivo Nome : Língua de Ensino:

6. Locate piezo ignitor button on top of heater. TO TURN OFF GAS TO APPLIANCE 1. Depress gas control knob slightly and turn clockwise to “OFF”. Page 11 VFM203 -NATURAL GAS VFM204 -L.P. GAS FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted by • If you cannot reach your gas supplier, call the hand. When lighting the pilot, follow these instruc-fire department. tions exactly. C. Use only your hand to push in or turn the gas B. BEFORE LIGHTING smell all around the appliance control knob. Never use tools. If the knob will not area for gas. Be sure to smell next to the floor push in or turn by hand, don’t try to repair it, call a because some gas is heavier than air and will settle qualified service technician. Force or attempted on the floor.repair may result in a fire or explosion. WHAT TO DO IF YOU SMELL GAS: D. Do not use this appliance if any part has been • Do not try to light any appliance. under water. Immediately call a qualified service • Do not touch any electric switch, do not use any technician to inspect the appliance and to replace phone in your building. any part of the control system and any gas control • Immediately call your gas supplier from a which has been under water. neighbor’s phone. Follow the gas supplier’s instructions. LIGHTING INSTRUCTIONS 1. STOP! Read the safety information above on this label. 2. Depress gas control knob slightly and turn clockwise to “OFF”. 3. Turn off all electric power to the appliance. 7. Turn gas control knob counterclockwise to Gas “PILOT”. Control 8. Depress gas control knob and hold in. Immediately Knob begin alternately pushing and releasing piezo ignitor button, observing pilot, until pilot is lit. Continue to hold the control knob in for about one (1) minute after the pilot is lit. Release the gas control knob and it will pop back up. Pilot NOTE: Knob can not be turned from “PILOT” to “OFF” unless should remain lit. If pilot goes out, repeat steps knob is depressed slightly. Do not force. 2 thru 7. • If knob does not pop up when released, STOP and 4. Wait five (5) minutes to clear out any gas. Then smell immediately call your service technician or gas for gas, including near the floor. If you smell gas, supplier. STOP! Follow “B” in the safety information above • If the pilot will not stay lit after several tries, turn on this label. If you don’t smell gas, go to the next the gas control knob to “OFF” and call your step. service technician or gas supplier. 5. Locate pilot in the cut-out below the burner. 9. Turn on all electric power to the appliance. 6. Locate piezo ignitor button on top of heater. 10. Turn gas control knob counterclockwise desired “LO” or “HI” setting. to TO TURN OFF GAS TO APPLIANCE 1. Depress gas control knob slightly and turn clockwise to “OFF”. 2. Turn off all electric power to the appliance if service is to be performed. Page 12 VFM303 -NATURAL GAS VFM304 -L.P. GAS FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted by • If you cannot reach your gas supplier, call the fire hand. When lighting the pilot, follow these instruc-department. tions exactly. C. Use only your hand to push in or turn the gas control B. BEFORE LIGHTING smell all around the appliance knob. Never use tools. If the knob will not push in or area for gas. Be sure to smell next to the floor turn by hand, don’t try to repair it, call a qualified because some gas is heavier than air and will settle service technician. Force or attempted repair may on the floor.result in a fire or explosion. WHAT TO DO IF YOU SMELL GAS: D. Do not use this appliance i...

Baixe o seu

Para fazer o download, introduza 2 dígitos :