Assessments - 2, GPA: 3.5 ( )

Fabricante : Louisville Tin and Stove Arquivo Tamanho: 291.64 kb Arquivo Nome : 66230cbf-6cf4-40f6-8074-ed23fd3bc06a.pdf Língua de Ensino:

22209. The NFPA standards are available from the national Fire Protection Association, 60 Batterymarch Street, Boston, Massachusetts 02110. Canadian standards are available from International Approval Services, 178 Rexdale Boulevard, Etobicoke, Ontario, Canada M9W 1R3. The design of this appliance was certified to comply with ANSI Z21.11.1 vented room heaters and CAN1-2.1-M86. Installer must leave these instructions with the consumer, have them complete, and return the warranty card. ROOM HEATER SPECIFICATIONS Your room heater comes packed in a single carton. Before installation, check the rating plate to verify that the Model Number is correct and that the room heater is equipped for the type gas you intend to use. SPECIFICATIONS TYPE CONTROL GAS MODEL NUMBERS CLOSED FRONT CLOSED FRONT RADIANT FRONT RADIANT FRONT THERMOSTAT BULB THERMOSTAT BULB THERMOSTAT BULB THERMOSTAT BULB NATURAL L.P. NATURAL L.P. VC201A-H VC202A-H N/A N/A VC351A-H VC352A-H VCR351A-H VCR352A-H VC501A-H VC502A-H VCR501A-H VCR502A-H VC701A-H VC702A-H VCR701A-H VCR702A-H HEIGHT WIDTH DEPTH 20” 24” 15-1/4” 26” 30” 15-1/4” 26” 30” 19-1/4” 30” 36” 19-1/4” INPUT (BTU/HR.) GAS INLET/OUTLET SIZE VENT SIZE 20,000 1/2X3/8” 3” 35,000 1/2X3/8” 4” 50,000 1/2X3/8” 4” 70,000 1/2X3/8” 5” CENTER OF VENT TO FLOOR NUMBER OF RADIANTS (“VCR” SERIES) NUMBER OF RADIANT GLASS (“VCR” SERIES) 16-1/2” N/A N/A 21-1/2” 5 2 21-1/2” 5 225-1/2” 5 2 APPROX. SHIPPING WEIGHT (“VC” SERIES) APPROX. SHIPPING WEIGHT (“VCR” SERIES) *OPTIONAL BLOWER MODEL 55 LBS. N/AN/A 84 LBS. 96 LBS. CHB-3 112 LBS. 124 LBS. CHB-3 138 LBS. 150 LBS. CHB-3 *Blowers also available factory mounted on 50M Btu units. All 70M Btu units come with blower mounted only. Page 2 INTRODUCTION THIS IS A GAS-FIRED, GRAVITY VENTED ROOM HEATER THAT WILL OPERATE SAFELY AND PROVIDE AN EFFICIENT SOURCE OF HEAT WHEN INSTALLED, OPERATED AND MAINTAINED AS RECOMMENDED IN THESE INSTALLATION AND OPERATING INSTRUCTIONS. READ THESE INSTRCTIONS THOROUGHLY BEFORE INSTALLING, SERVICING, OR USING THIS APPLIANCE. IF YOU DO NOT UNDERSTAND ANY PART OF THESE INSTRUCTIONS, CONSULT LOCAL AUTHORITIES, OTHER QUALIFIED INSTALLERS, SERVICE AGENCIES, THE GAS SUPPLIER, OR THE MANUFACTURER. VENTING This heater must be connected to a properly installed and maintained venting system. This heater is equipped with a vent safety shut-off device. Pilot outage will occur if the heater is not connected to a vent system. Pilot outage may occur due to restriction or blockage in the vent or if connected to a masonry chimney having an area greater than the vent size shown on Page 2. This appliance should be vented through a properly sized listed type B vent that has been constructed in accordance with the National Building Code. If a horizontal section of vent is used, it must slope upwards a minimum of . inch per foot of length. This heater must not be connected to a vent system being used for wood or coal burning appliances. The use of more than one appliance per vent system will most likely cause the vent safety shut-off device to shut off the heater due to the cooling of vent temperatures through the draft diverter of the second appliance. In some situations, the vent safety shut-off may shut down the heater if a too large, unlined, masonry chimney is used. Due to low vent temperatures associated with more efficient heaters it may take too long to get the vent action going in a chimney before the shut-off device will shut down the heater. If this is the case, we recommend lining the chimney with the proper size type B vent pipe or type ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :