Assessments - 1, GPA: 3 ( )

Fabricante : Sunbeam Arquivo Tamanho: 641.63 kb Arquivo Nome : Língua de Ensino:

electric shock, or injury to persons. The use of OPERATION. the unit. turn the heater OFF, and unplug the unit. Carefully 3. The heater is hot when in use. To avoid burns, DO attachments not recommended or sold by the 1. Carefully remove your heater from the box. Please 3. After cleaning, be sure to completely dry the unit remove the obstruction and follow the reset NOT let bare skin touch hot surfaces. If provided, use manufactuer may cause hazards. save the carton for off-season storage. with a cloth or towel. instructions. handles when moving this heater. Keep combustible 13. DO NOT use outdoors. 2. Make sure the unit is in the OFF ( I/O ) position Figure 1 CONTROL PANEL 4. Store heater in a cool, dry location. • The temperature may be set too low. Turn the materials, such as furniture, pillows, bedding, papers, 14. To prevent a possible fire, DO NOT block air intakes or before plugging the heater into the outlet. 5. The manufacturer recommends that you store the Thermostat Control clockwise until the heater restarts. clothes, and curtains at least 3 ft (0.9 m) from the exhaust in any manner. DO NOT use on soft surfaces, 3. Place heater on a firm, level surface. At 1500 watts, OFF 1Heat2ThermostatBFAN LOW HEAT HIGH HEAT unit in its original carton. • Make sure Mode Control is in LOW (1) or HIGH (2) front of the heater and keep them away from the like a bed, where openings may become blocked. this unit draws 12.5 Amps. setting. sides and rear. 15. To disconnect heater, turn controls to OFF, then Mode Control Please DO NOT attempt to open or repair the heater. AUTO SAFETY SHUT-OFF 4. DO NOT run cord under carpeting. DO NOT cover remove plug from outlet. Turn the Mode Control to the desired setting: Please see the Warranty for Service Instructions. cord with throw rugs, runners, or the like. Arrange 16. Avoid the use of an extension cord because the This heater is equipped with a patented, technologically- cord away from traffic area and where it will not be extension cord may overheat and cause a risk of I/O - Off Mode advanced, ceramic controlled safety system that requires tripped over. fire. However, if you have to use an extension cord, If you want to shut off the heater at any time of A the user to reset the heater if there is a potential If you have any questions regarding your product or overheat situation. When a potential overheat 5. This heater is not intended for use in bathrooms, the cord shall be No. 14 AWG minimum size and operation, turn the Mode Control to Off ( I/O ) position. would like to learn more about other Sunbeam® temperature is reached, the system will automatically laundry areas and similar indoor location. NEVER rated not less than 1875 watts. Power Light may remain lit until the heater is unplugged. A. MODE CONTROL (OFF, FAN, LOW, HIGH) products, please contact our Consumer Service locate heater where it may fall into a bathtub or 17. If the heater will not operate, see specific instructions shut the heater off. It can only resume operation when Department at 1-888-264-9669 or visit our website at -Fan only Setting B. THERMOSTAT CONTROL other water container. on Auto Safety Shut-off. the user resets the unit. 6. Extreme caution is necessary when any heater is 18. DO NOT attempt to repair or adjust any electrical or Heater will run at fan-only operation without heat output. used by, or near children or invalids, and whenever mechanical functions on this unit. Doing so will void To Reset the Heater: 1 - LOW Heat the heater is left operating and unattended. your warranty. The inside of the unit contains no user If the unit shuts down: 7. Always unplug the heater when not in use. serviceable parts. All servicing should be performed The heater will run continuously at 1000W. 1. Turn Mode Control to OFF ( I/O ) and Thermostat Figure 2 8. When unplugging, be sure ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :