Assessments - 2, GPA: 3.5
(
)
)
|
Facilidade de uso
Return unit to authorized service facility for examination, electrical or mechanical adjustment, or repair. 4. Do not run the cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over. 5. To disconnect the unit, turn the controls off, then remove the plug from the outlet. 6. Do not modify the electric fireplace. Use it only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. 7. Do not burn wood or other materials in the electric fireplace. 8. Do not strike the fireplace glass. 9. Always use a certified electrician should new circuits or outlets be required. 10.Always use properly grounded, fused and GFI outlets. 11.Disconnect all power supply before performing any cleaning, maintenance or relocation of the unit. 12.Do not use a pressure washer to clean unit. 13. When transporting or storing the unit and cord, keep in a dry place, free from excessive vibration and store so as to avoid damage. NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, illness or death. Model Number Serial Number MODEL AND SERIAL NUMBER INFORMATION If you have any questions regarding our products please have the product model and serial numbers available upon calling Dimplex customer service or technical support. To locate the model and serial number labels see below. Record the Model number, Serial number, and CAT number on the front cover of this manual for future reference. Model Number Model Number Serial Number Firebox Carton 2 Serial Number Figure 1 NOTE 1 A 15amp, 120 volt outdoor GFI is required. Additional appliances on the same circuit may exceed the current rating of the circuit breaker. WARNING Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons. Construction and electrical outlet wiring must comply with local/national building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons. Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury to persons, always use a licensed electrician. SITE SELECTION AND PREPARATION This section provides instructions for selecting a location and preparing the site to install the fireplace into your Dimplex mantel surround. 1. Select a suitable location. 2. For ease of electrical hook up you may wish to locate the fireplace near an existing outlet. (Refer to NOTE 1). NOTE The dimensions of the fireplace are 27.60”wide X 20.10” high X 9” deep. The viewing area is 26” wide and 13” high. 20 Feet Figure 2 FIREPLACE INSTALLATION Dimplex Mantel Surround Kit 1. Install the fireplace assembly only into the Dimplex outdoor mantel. (refer to mantel assembly instructions) 2. Select a suitable location that is level and away from high traffic New Wall Construction NOTE: This unit must be removable from opening. 1. Select a suitable location. 2. The fireplace insert comes completely assembled and wired. Some tools may be required to prepare the site and assembly. The dimensions of the required opening are 27” wide X 19.75” high X 13.50” deep. (FIGURE 3). This fireplace does not require any venting. Figure 3 5” clearance for transformer and GFI receptacle OPERATION ELECTRIC FIREPLACE MANUAL CONTROL The manual controls for the firebox are located in the upper right hand corner behind the access panel. To access the controls, open the upper access panel by pulling forward and down. To locate controls refer to Figure 3. NOTE: The main on/off switch/flame action and flame brightness controls are always illuminated as long as the unit is plugged in. A. Main On/Off Switch The ON/OFF SWITCH supplies power to the flames and over head lights. B. Flame Action Control Press the up or down arrow to adjust the flame speed to the desired level. C. Flame Brightness Control Press the up or down arrow to increase or decrease the brightness of the over head lights. D. Storage Compartment A convenient location to place your CD’s or MP3 player. E. Audio Input Plug Using the audio cord included, a CD or MP3 player may be connected to the firebox. NOTE: This unit does not have a heat option Audio Input Plug Storage Compartment Flame Action Flame Brightness Figure 3 Main On/Off Switch MAINTENANCE WARNING Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. COVERING YOUR DIMPLEX OUTDOOR FIREPLACE When not in use, cover your Dimplex outdoor firep...