Log:
Assessments - 3, GPA: 3.7 ( )

Instruções de Operação Vermont Casting, Modelo GPFMN

Fabricante : Vermont Casting
Arquivo Tamanho: 930.3 kb
Arquivo Nome : b8e76baa-26b2-4d9f-9c47-f854d4eff619.pdf
Língua de Ensino: en
Ir para baixar



Facilidade de uso


FOR YOUR SAFETY • Installation and service must be performed by a qualified installer, service agency or the gas supplier. • Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. FOR YOUR SAFETY: If you smell gas: • Do not touch any electrical switches • Do not try to light any appliance. Extinguish any open flame • Do not use the phone in your building • Immediately call your gas supplier from a neighbor’s phone • Follow your gas supplier’s instructions • If you cannot reach your gas supplier, call the fire department WARNING: For outdoor use only! WARNING: Do not use for cooking! Gas Patio Fire Models: GPFMN, GPFMP 4237 Homeowner’s Installation and Operating Manual 9DX5 ANSI Z21.58-1995; CGA 1.6-M95; IAS/US 4-96 INSTALLER: Do Not Discard This Manual, Leave For Homeowner 20004237 5/02 Rev. 4 Vermont Castings Gas Patio Fire General Information Model GPF is a decorative gas log set for outdoor use only. This appliance must not be used for cooking. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty. WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. WARNING: This appliance shall be used only outdoors in a well-ventilated space and shall NOT be used inside a building, garage or any other enclosed area. WARNING: This log set must NOT be installed in an unvented appliance. WARNING: This unit is not for use with solid fuel. NOTE: All new LP cylinders (and in many cases used cylinders) may contain water, air or other contaminants. It is essential that these be removed before filling the cylinder and placing into service. Water vapor present in the gas vapor may cause the regulator to “freeze up” and cause an interruption to the gas flow. This interruption will cause the unit to shut down. To prevent this from occurring, it is essential that a qualified individual ALWAYS purge a new tank thoroughly before placing it into service. It is recommended that cylinders that have not been used for extended periods of time also be purged before use. The installation must conform with Local Codes or, in the absence of local codes, with the National Fuel Gas Code ANSI Z223.1 or CSA-B149.1 Installation Code. The appliance and its individual shut off valve must be disconnected from the gas supply piping system during any pressure testing or the system at test pressure in excess of 1/2 psig (3.5kPa). This appliance must be isolated from the gas supply piping system by closing its individual manual shut off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3kPa). Always keep the appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids. • Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. •Young children should be carefully supervised when they are in the area of the appliance. • Never leave the unit unattended during operation. • Clothing or other flammable materials should not be hung from the appliance, or placed on or near the appliance. • Installation and repair should be done by a qualified service person. The appliance should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It is imperative the control compartment, burners and circulating air passageways of the appliance be kept clean. • Inspect the fuel supply connection (including the hose for LP models) before each use of the appliance. • If it is evident there is excessive abrasion or wear, or the hose is cut, it must be replaced prior to the appliance being put into operation. • The pressure regulator and hose assembly supplied with LP models must be used. Replacement pressure regulators and hose assemblies must be those specified in this manual. • The LP gas supply cylinder used with LP models must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S. Department of Transportation (DOT) or the specifications in the National Standard of Canada, CAN/CSA B330, Cylinder, Spheres and Tube for Transportation of Dangerous Goods as applicable. • Cylinders must be stored outdoors in a well-ventilated area out of reach of children. Disconnected cylinders must have threaded valve plugs tightly installed and must not be stored in a building, garage or any other enclosed area. • Storage of this appliance indoors is permissible only if it has been disconnected form its fuel supply (natural gas line or LP gas cylinder). • The LP gas cylinder supply system must be arranged for vapor withd...

Este manual também é adequado para os modelos :
Lareiras - GPFMP (930.3 kb)

Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias