Assessments - 3, GPA: 4 ( )

Fabricante : Napoleon Fireplaces Arquivo Tamanho: 1.49 mb Arquivo Nome : Língua de Ensino:

Note - Burners are omitted in this view for clarity. WARNING: AIR SHUTTER ADJUSTMENT SHOULD ONLY BE PERFORMED BY A QUALIFIED PROFESSIONAL SERVICE TECHNICIAN. NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 7 Log Placement Figure 7 Millivolt Appliance Checkout The pilot flame should be steady, not lifting or floating. Flame should be blue in color with traces of orange at the outer edge. The top ..." (10 mm) at the pilot generator (thermopile) and the top ..." min (tip) of the quick drop out thermocouple should be engulfed in the pilot flame. The flame should project 1" (25 mm) beyond the hood at all three ports. See Figure 9. To light the burner, refer to the lighting instructions on pages 12 and 13. Figure 6 Figure 9 Note: If the burners have been removed for any reason, rear burner must be installed before front burner. See Figures 7 and 8. Install the unitized log set: a - The bottom of the log set is notched to accommodate the pilot. b - Place the log set so that the four inner notches on the underside of the log set fit over the four risers located on the burner ends. See Figure 6. This procedure is accomplished primarily by feel, as the log set masks the burner risers as it is being installed. c - As a final check for correct log set placement, check that the four outer notches on the underside of the log set fit over the burner tines as indicated in Figure 6. The log set, the decorative volcanic stone and the glowing embers (rockwool) are located inside the unit. Refer to the following information and Figures 6 and 7 for detailed placement instructions for the logs, the decorative volcanic stone and the glowing embers. Figure 6 also shows a typical flame pattern for this particular appliance. Install the decorative volcanic stone and glowing embers (rockwool): Spread the decorative volcanic stone on the simulated brick floor of the firebox around the burners to simulate ashes. Maintain a ... in. gap between the bottom of the horizontal grate section and the top of the pile of decorative volcanic stone. Place a few dime-sized pieces of the glowing ember material on the pan burner in front of the burned out area on both sides of the log set. The glowing embers may touch one another, but should not overlap each other. Figure 8 FRONT OF FIREPLACE REAR BURNER FRONT BURNER Outer Log Notch Location FIREBOX SUBFLOOR Outer Log Notch Location Outer Log Notch Location Outer Log Notch Location Riser - Inner Log Notch Location LOG NOTCH LOCATION RELATIVE TO BURNER Pilot Assembly Riser - Inner Log Notch Location NOTE: INSTALL REAR BURNER FIRST, THEN FRONT BURNER. BURNER POSITIONING REAR BURNER FRONT BURNER PILOT BURNER Note: The burners are not identical. Position them so that the circular burner ports run as shown. Note especially the vertical run of ports relative to the pilot burner. Bracket A on the rear burner will interfere with the pilot burner if an attempt is made to install the rear burner in the front burner’s position. BRACKET A BURNER PORTS NO...

Baixe o seu

Para fazer o download, introduza 2 dígitos :