Assessments - 2, GPA: 5 ( )

Fabricante : Lindy Arquivo Tamanho: 694.33 kb Arquivo Nome : 20701.pdf Língua de Ensino:

20704 © LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH -FIRST EDITION ( Jul 2001) Module Cover Terminals 2-Port-PCB Chassis Shielding Contact Strain Relief Ground Connector PCB-terminals optimised for fast data transfer Strain relief’s are attached - so they won’t get lost Additional strain relief by use of a cable tie is possible Foil- or Braid shielded cable Module Cover Terminals 2-Port-PCB Chassis Shielding Contact Strain Relief Ground Connector PCB-terminals optimised for fast data transfer Strain relief’s are attached - so they won’t get lost Additional strain relief by use of a cable tie is possible Foil- or Braid shielded cable English Manual LINDY GigapatchPanel The LINDY GigaPatchPanel is supplied with 16 or 24 Cat 6 ports. The new modular construction allows you to install the panels with any even number of ports between 2 and 24, partially equipped panels can be extended or completed with the addition of dual modules at any time. This means that the valuable space inside your rack can be fully optimised, for the future expansion of your network. The newly developed LSA-rct technology allows a fast and reliable connection of the wires to the terminals. Each unit is supplied with a suitable crimping tool, however there is also a premium tool available which allows you to connect 4 wires simultaneously and thus helps to increase efficiency and lower the costs of the network installation. • Up to 12 shielded dual RJ45 Cat 6 modules per unit • • • • Coding scheme both, EIA/TIA 568 A and B • Crimping tool supplied • Connection via LSA-rct terminals • Cores with 22-24 AWG can be accommodated • Pairs can be lead directly to the terminals – no need to untwist them Preparation of the cable Cut away the outer sheath by approx 65mm with a cable or sharp knife. Make sure to cut only as deep as the shielding allows, don’t damage the insulation of the wires! Cut the foil or the braid shielding as shown in the picture so that you leave approx 10mm of the shielding. Wind the shielding wire around the 10mm left of the shielding, it will be clamped later beneath the strain relief. untwist 13 mm at most If present, shorten the shielding foil of the single pairs (Pimf-cable only) to the same length. Untwist the pairs for 13mm at most and connect the wires using the following colour scheme NEXT – Pairs 1,2 – 3,6 NEXT – Pairs 3,6 – 4,5 English Manual Mounting 1. Mount the strain relief and the shielding braid or 2. Connect the individual wires foil as shown in the picture. The flexible strain reliefs will avoid squeezing the solid core cables Note: The colour schemes TIA 568-A and TIA 568-B too heavily. must not be mixed within one network structure 3. Snap in the cover 4. Mount the cover screw Pinout of a module confirming ISO/IEC 11081 Terminals Terminals Jack Jack Ground connector Colour scheme for 100Base -T and 1000BaseT Jack Pin # Wire colour EIA/TIA 568A Wire colour EIA/TIA 568B 1 green/white orange/white 2 green orange 3 orange/whit...

Baixe o seu

Para fazer o download, introduza 2 dígitos :