Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
Systemboard Connectors PCI 2.3: connectors two 120-pin connectors data width (maximum) 32 bits PCI Express x1: connectors one 36-pin connector data width (maximum) one PCI Express lane PCI Express x16: connectors one 164-pin connector data width (maximum) 16 PCI Express lanes Serial ATA four 7-pin connectors Memory four 240-pin connectors Internal USB device one 10-pin connector (supports two USB ports) Processor fan one 4-pin connector System fan one 3-pin connector Front panel control one 9-pin connector Front panel audio one 10-pin connector SPDIF audio one 6-pin connector Processor one LGA1156 connector Power 12V one 4-pin connector Power one 24-pin connector Controls and Lights Front of the computer: Power button push button Power light off — system is either turned off or is not receiving power blue — system is fully functional and in the On state. Blinking blue indicates sleep state of the computer. amber — solid amber light when the computer does not start indicates a problem with the system board or power supply. Blinking amber light indicates a problem with one of the devices in the system. Drive access light displays the SATA hard drive or CD/DVD activity. blue light — blinking blue light indicates that the computer is reading data from or writing data to the drive(s). Back of the computer: Link integrity light on integrated network adapter off — system is off or is not detecting a physical connection to the network. green — A 10 or 100 mbps connection exists between the network and the computer. orange — A 1000 mbps connection exists between the network and the computer. Network activity light on integrated network adapter yellow light — A blinking yellow light indicates that network activity is present. Power supply diagnostic light green — A green light indicates that the 5 V standby power is OK. Power DC power supply: Wattage 350 W non-EPA Maximum heat dissipation (MHD) 1837 BTU/hr Voltage 100–127 V/200–240 V, 50–60 Hz, 10/5 A Coin-cell battery 3 V CR2032 lithium coin cell NOTE: Heat dissipation is calculated by using the power supply wattage rating. NOTE: See the safety information that shipped with your computer for important voltage setting information. Physical Height 370.40 mm (14.58 inches) Width 170.00 mm (6.69 inches) Depth 433.78 mm (17.08 inches) Weight 7.95 kg–10.50 kg (17.53 lb–23.15 lb) Environmental Temperature: Operating 10 °C to 35 °C (50 °F to 95 °F) Storage –40 °C to 65 °C (–40 °F to 149 °F) Relative humidity (noncondensing) operating: 20% to 80% (maximum wet bulb temperature: 29 °C) storage: 5% to 95% (maximum wet bulb temperature: 38 °C) Maximum vibration: Operating 5 Hz–350 Hz at 0.0002 G2/Hz Storage 5 Hz–500 Hz at 0.001 to 0.01 G2/Hz Maximum shock: Operating 40 G +/– 5% with pulse duration of 2 msec +/– 10% (equivalent to 20 in/sec [51 cm/sec]) Storage 105 G +/– 5% with pulse duration of 2 msec +/– 10% (equivalent to 50 in/sec [127 cm/sec]) Altitude: Operating –15.2 m to 3048 m (–50 ft to 10,000 ft) Back to Contents Page Storage –15.2 m to 10,668 m (–50 ft to 35,000 ft) Airborne contaminant level G2 or lower as defined by ISA-S71.04-1985 Chassis Fan Dell Precision™ Workstation T1500 Service Manual Removing the Chassis Fan 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the Cover. 3. Disconnect the fan cable from the system board. 4. While holding the chassis fan in place, remove the two screws that secure the fan to the chassis. WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at 5. Ease the fan towards the center of the computer, and lift the fan out of the chassis. Replacing the Chassis Fan To replace the chassis fan, perform the above step in reverse order. Back to Contents Page Coin-Cell Battery Dell Precision™ Workstation T1500 Service Manual Removing the Coin-Cell Battery 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the Cover. 3. Gently press the release latch away from the battery. 4. Lift the coin-cell battery out of the computer. WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at Replacing the Coin-Cell Battery To replace the coin-cell battery, perform the above steps in reverse order. Back to Contents Page Back to Contents Page Front Panel Dell Precision™ Workstation T1500 Service Manual Removing the Front Panel 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the Cover. 3. Gently lift the clips that secure the front panel to the chassis. 4. Rotate the front panel away from the computer. WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best ...