Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
Release Notes
Tips and Tricks
Tips and Tricks
The following tips will help you overcome some issues you many encounter while deploying your
Integrity server.
•
Install Service Pack 1 - This upgrade is necessary for Intel® Dual Core Itanium® 2 processor
support.
•
Enable hyper-threading on Integrity servers - The default setting for hyper-threading is off. To
enable hyper-threading go to the EFI shell and enter the command cpuconfig threads on. To
disable hyper-threading go to the EFI shell and enter the command cpuconfig threads off.
•
Enable remote desktop connection from a headless server - The remote administration mode is
enabled by default on Windows Server 2003 if you are using the OS supplied as part of the HP
Reinstall media. If you are installing or reinstalling using Microsoft RTM media, the Remote
Desktop functionality is disabled. To enable remote desktop connection go to the SAC prompt and
enter:
reg add “HKLM\System\CurrentControlSet\Control\Terminal Server” /v
fDenyTSConnections /t REG_DWORD /d 0 /f
•
Enable greater than 256 interrupts (cell-based servers only) - When using Windows Server
2003 Enterprise Edition on cell-based servers, the system on allows 256 interrupts.To overcome
this limitation apply QFE 900713, then add /EXTINTVEC to the boot options using NVRBOOT
•
Disconnect all drives except the boot drive prior to OS installation - Only the target OS drive
should be connected during installation. This ensures that the OS is installed on the correct drive.
Make sure that the Z: drive letter is free. Windows Server 2003 with SP1 creates the EFI partition
here.HP recommends that you install the boot controller in the root cell.
•
Default MP/iLO settings for cell-based and entry-level servers - For cell-based servers, the MP
is assigned a static IP address at the factory before it ships. It is not assigned a DNS name and it is
not DHCP enabled. If you are performing a headless server installation, you can connect to the MP
over a LAN (instead of using a serial cable) by using this static IP for initial configuration of the
MP. The default IP address of a cell-based server’s MP is 192.168.1.1. The default username and
password are Admin and Admin. Change the IP address and the default password at installation.
For entry-level servers with iLO MPs, the MP is assigned a default DNS name at the factory and is
DHCP enabled. It is not assigned a default IP address. The default hostname can be deduced from
the MP's MAC address. The hostname is of the form mp
MAC code of the MP's NIC. The MAC address of the MP LAN interface is typically located on a
sticker on the back of the server.
•
Set Cell Local Memory to 100% (cell-based servers only) - HP recommends that you set the
Cell Local Memory (CLM) parameter to 100% for optimal server performance.
•
Loading OEM boot drivers - Boot drivers can only be installed from the Windows installation
CD or a floppy disk. Integrity servers don’t have floppy drives, so boot drivers that are not on the
Windows CD must be loaded into memory and then installed. EBSU shows devices that it detects
and that have a virtual floppy image available. To load the driver:
— Boot the server. Load the HP Smart Setup media into the server DVD drive.
— From the EFI Boot Menu, select Internal Bootable DVD and press Enter.
— From the main menu select Load OEM Boot Driver and press Enter to continue.
HP Integrity Servers with Microsoft® Windows® Server 2003, Enterprise Edition
41
...
Computadores - HP Integrity Superdome sx2000 Server (134.66 kb)
Computadores - HP Integrity rx7620 Server (134.66 kb)
Computadores - HP Integrity rx7640 Server (134.66 kb)
Computadores - HP Integrity rx8620 Server (134.66 kb)