Assessments - 2, GPA: 4
(
)
)
|
Facilidade de uso
Non-observance could cause a fatal electric shock! • Never attempt to open the housing yourself. • Do not place any kind of object into the inside of the housing. • Do not use the appliance with wet hands, on a damp floor or when the appliance itself is wet. • Do not touch the plug with wet or damp hands. • Check the cord and the plug regularly for any possible damage. If the cord or plug is damaged, it must be replaced by the manufacturer or a qualified person in order to avoid a hazard. • Do not use the appliance if it is dropped or otherwise damaged or if the cord or plug are damaged. In the case of damage, take the appliance to an electrical repair shop for examination and repair if necessary. GB GBGB • Never attempt This could • Do not allow the flames. Remove • For extra protection breaker with a rated breaking Ask your electrician for • Make sure that there is no cause anyone to trip when in • If an extension cord is used it must otherwise overheating of the extension • This appliance is not suitable for commercial • Never leave the appliance unattended while • Children cannot recognise the dangers involved Therefore never allow children to use household • Always remove the plug from the socket when the is cleaned. • Danger! Nominal voltage is still present in the appliance as long the mains socket. • Switch the appliance off before disconnecting from the mains. • Never use the cord to carry the appliance. SPECIFIC SAFETY ADVICE • Important Note: Never use the device for more than 3 consecutive minutes. Before operating the device again, let it cool down to room temperature first. • Careful! The cutting knife (8) is very sharp. You should exercise extreme caution when cleaning the device. • After you finish cutting, always set the On/Off switch (2) back to the 0 position. Also, set the dial (11) back to the minimal cutting strength. Pull the power plug. • Never feed the device with your bare hands. Always use the cutting sled (6) and the leftover tray (4) to do so. • Attention! Do not use the device, unless all parts are properly installed. • Remove the cut food, only once the cutting knife (9) has come to a complete stop. • Careful! The leftover tray (4) has very sharp edges. You should exercise extreme caution when cleaning the device. • The device is suitable for cutting of bread, sausage, meat, vegetables and fruit. You should not use it to cut: • Meat with bones • Foods with pits • Hard, inedible parts of foods • Frozen foods • Twisted and rolled roasts As well as similar foods. PRIOR TO FIRST USE • Remove all packaging. • Clean the device as described in Care and Maintenance. OPERATION • Place the device on a flat, stable surface and flap down the footing (7) . • To insert the cutting sled into the device, align the arrow of the sled (6) with the arrow of the footing (7) . The sled is now connected to the footing (7) and can be slid back and forth. • Insert the leftover tray (4) from the top into the duct of the sled (6) , as shown in the illustration below the assembly. • Adjust the dial (11) to the desired cutting strength. • Place the food on the cutting sled (6) and use the leftover tray (4) to lightly push the food towards the cutting knife (8) . 5 6 GB GBGB • Connect the (10) to a suitable • Set the On/Off switch (2) to either 1,2 or 3. • Now you can press (1) . The cutting knife (8) will start to rotate. release the safety switch, Careful! As the device is powered, caster of the device will stop. • The cutting sled (6) can be steadily and lightly pushed • Should the rotation speed of the the food against the knife (8) . Wait a moment for the knife to regain • Once you are finished, always set the switch (2) back to the 0 position. Pull the plug. • Tip: When you wish to cut very thin slices, (8) with a moist cloth. This prevents the food from sticking to the knife. While moistening connected to a power outlet! • Important note: Never use the device for more than 3 consecutive minutes. Before operating the device again, let it cool down to room temperature first. CARE AND MAINTENANCE • Please also observe the safety advice. • Pull the power plug. • Remove the leftover tray (4) and the sled (6) . To do so, slide the sled (6) along the footing (7) until the arrows are aligned. Now you can lift the sled (6) and remove it. The leftover tray (4) and the sled (6) can be cleaned with lukewarm water and some dishwashing detergent. • The device can be cleaned with a moist cloth after use and should be thoroughly another cloth afterwards. • Never use abrasive or aggressive detergents or utensils. • Never use gasoline or thinners to clean the device. • For easy cleaning, the knife (8) can be removed as follows: Turn the wing screw of the knife locking clockwise. Hold the knife by the screw and carefully lift it out. Clean the knife (8) with running water and some dishwashing detergent. For best results, use a dish mop. The inside actuation parts may not be exposed to water. Therefore, thoroughly dry ...