Assessments - 2, GPA: 3.5
(
)
)
|
Facilidade de uso
To remove the blade, first remove the hex socket head bolt which secures the dust box, then remove the dust box. Thumb screw - After installing the blade, install the dust box and tighten the hex socket head bolt to secure the dust box. To remove the blade, press the shaft lock so that the blade cannot revolve and use the hex wrench to loosen the bolt clock- wise. Then remove the bolt, outer flange and blade. Hex wrench (Counterclockwise) Then remove the hex socket head bolt. outer flange and blade. Outer flange Hex socket head bolt To install the blade, follow the removal pro- cedures in reverse. Install the cup washer, inner flange, saw blade, outer flange and hex socket head bolt on the spindle in that order. BE SURE TO TIGHTEN THE HEX SOCKET HEAD BOLT SECURELY. Outer flange Hex socket head bolt CAUTION: Be sure the blade is installed with teeth pointing up at the front of the tool. Use only the Makita hex wrench to install or remove the blade. After install the blade, install the dust box and tighten the hex socket head bolt to secure the dust box. OPERATION Hold the tool firmly. Set the base plate on the workpiece to be cut without the blade making any contact. Then turn the tool on and wait until the blade attains full speed. Now simply move the tool forward over the workpiece surface, keeping it flat and advancing smoothly until the sawing is completed. To get clean cuts, keep your sawing line straight and your speed of advance uniform. CAUTION: .Always gently keeps the tool moving straight ahead when cutting. Forcing or twisting the tool will result in overheating of the motor and dangerous kickback, possibly causing severe injury. If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery. Use a shallow depth of cut when cutting thin workpieces for cleaner, safer cuts. (For 5026DA, 5026DB, 5036DA and 5036DB only) For 5046DA and 5046DB only When you cut angle materials or the like, the lower guard (safety cover) may rest on the angle. Angle Lower guard (safety cover) rests on angle If so, tilt other rear of the tool to prevent this. Tilt rear of tool When cutting thin sheet metals such as corrugated metal, always cut them at a position more than 20 mm (25/32”) away from the edge. If you cut them at a position closer to the edge, a piece cut off could be sucked into the dust box, causing a severe injury. I I More than 20 mm (25132’) CAUTION: Never use a deformed or cracked blade. Always replace it with a new one. When the battery charge runs low, the blade easily becomes stuck, and the blade tips can break. Always recharge the battery cartridge when the blade rpm slows down. Do not stack materials when cutting them. Do not cut hardened steel. Do not touch the saw blade, workpiece or cutting chips with your bare hand immediately after cutting; they may be extremely hot and could burn your skin. Do not connect the saw to a vacuum cleaner when c...
Este manual também é adequado para os modelos :Jig Saw e - 5026DA (1.1 mb)
Jig Saw e - 5046DWA (1.1 mb)
Jig Saw e - 5026DB (1.1 mb)
Jig Saw e - 5026DWB (1.1 mb)