Assessments - 3, GPA: 4.7
(
)
)
|
Facilidade de uso
Twisting the saw can cause the back edge of the blade to dig into the material, climb out of the work and run back toward the operator. • Avoid cutting nails. Inspect for and remove all nails from lumber before cutting. • Some wood contains preservatives such as copper chromium arsenate (CCA) which can be toxic. When cutting these materials, extra care should be taken to avoid inhalation and minimize skin contact. BATTERY CAP INFORMATION Battery storage and carrying caps are provided for use whenever the battery is out of the tool or charger. Remove cap before placing battery in charger or tool. WARNING: Do not store or carry battery so that metal objects can contact exposed battery terminals. For example, do not place battery in aprons, pockets, tool boxes, product kit boxes, drawers, etc. with loose nails, screws, keys, etc. without battery cap. Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials such as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit transporting batteries in commerce or on airplanes (i.e. packed in suitcases and carryon luggage) UNLESS they are properly protected from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit. IMPORTANT SAFETY INSTRUCTIONS • SAVE THESE INSTRUCTIONS. • Before using charger, read and understand all instructions and cautionary markings on (1) charger, (2) battery pack, and (3) product using battery pack. DANGER: 120 volts present at charging terminals. Do not probe with conductive objects. Danger of electric shock or electrocution. DANGER: If battery pack case is cracked or damaged, do not insert into charger. Danger of electric shock or electrocution. DANGER: Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks, return to a service center for recycling. WARNING: Don’t allow any liquid to get inside charger. Electric shock may result. CAUTION: To reduce risk of injury, charge only Black & Decker rechargeable batteries. Other types of batteries may burst, causing personal injury and damage. • To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as in a metal shed, or an uninsulated trailer. • Do not expose charger to rain or snow. • Use of an attachment not recommended or sold by Black & Decker may result in risk of fire, electric shock, or injury to persons. • This charger is not intended for any uses other than charging Black & Decker rechargeable batteries. Any other uses may result in risk of fire, electric shock or electrocution. • To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger. • Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. • An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in risk of fire, electric shock, or electrocution. If an extension cord must be used, make sure: • That the pins on plug of extension cord are the same number, size and shape of those of plug on charger. • That extension cord is properly wired and in good electrical condition and the wire size is large enough for AC ampere rating of charger as specified below. An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is, 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size. RECOMMENDED MINIMUM AWG SIZE FOR EXTENSION CORDS TOTAL EXTENSION CORD LENGTH (FEET) 25 50 75 100 125 150 175 WIRE GAUGE 18 18 16 16 14 14 12 • The charger is ventilated through slots in the housing. Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. • Do not operate charger with damaged cord or plug — have them replaced immediately. • Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to an authorized service center. • Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly may result in risk of electric shock, electrocution or fire. • The charger is designed to operate on standard120 VAC, 60Hz household electrical power. Do not attempt to use it on any other voltage. • To reduce risk of electric shock, unplug charger from outlet before attempting any cleaning. Removing ...
Este manual também é adequado para os modelos :Jig Saw e - FS2400CS (502.77 kb)