Assessments - 2, GPA: 4
(
)
)
|
Facilidade de uso
Look to Attwood for quality replacement parts and marine accessories. SAVE THESE INSTRUCTIONS Form Number 69357 Rev. B 03-10 3® APPLICATION This holder will accommodate push poles up to 1-1/2" (3,8cm) in diameter. Installation requires three Attwood Push Pole Holders – the two outside holders facing one direction, the middle holder facing the opposite direction. NOTE: It is recommended that a boat builder, boat dealer, or a qualified marine mechanic perform the installation of the Attwood Pole Holder. REQUIRED FOR INSTALLATION • Cordless drill and bits • Sabre saw • Screwdriver • Marine sealant • Length of 3/8" (9,5mm) I.D. hose (for optional 1496-1 Drainage Receptacle) WARNING: To prevent personal injury, always remove the boat from the water before using any 120V AC power tools. LOCATION: Select an installation location that meets the following criteria: • Each cutout location must be large enough (see Figure 1) and deep enough to accommodate the retracted Pole Holder. • Access to the underside of the mounting surface is necessary to fasten the optional Drainage Receptacle (1496-1). 1.." 3.." 2..." Figure 1 2" NOTE: Before you drill or cut a hole on your boat, BE ABSOLUTELY CERTAIN there is room for the unit to fold in beneath the deck or gunwale where it will be installed. The Pole Holder, in the down position, will be recessed beneath the deck or gunwale. 1. Use template provided to mark opening in deck (Figure 1). 2. Cut opening using sabre saw. Place a bead of marine sealant around opening (Figure 2). Figure 2 3. If installing Pole Holder only: Place Pole Holder into cutout and fasten with four #8 flat head self-tapping stainless steel screws. 4. If installing with the optional Drainage Receptacle (1496-1): Use template provided and drill four 1/4" (6,4mm) holes where indicated. Place Pole Holder into cutout from above the deck. Hold Drainage Receptacle below deck and line up with holes of Pole Holder. Fasten together with four #8 stainless steel machine screws and nuts. 5. Connect 3/8" (9,5mm) I.D. hose to the fitting on the Drainage Receptacle, then route hose into bilge or to a drain fitting. ATTWOOD LIMITED WARRANTY ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan 49331 (“Attwood”) warrants to the original consumer purchaser that Attwood brand products will be free from defects in materials and workmanship under normal use and service for one year from the date of original consumer purchases. This limited warranty is not applicable if the product has been damaged by accident, improper installation, unreasonable or improper use, lack of proper maintenance, unauthorized repairs or modifications, normal wear and tear, or other causes not arising out of defects in materials or workmanship. Attwood p...
Este manual também é adequado para os modelos :Barcos - 1492 (428.13 kb)
Barcos - 69357 (428.13 kb)