The cross bars must be removed from the hulls for the initial installation only. 1. Drill out the rivets holding the cross bar end caps in place, remove the end caps. This may require drilling a hole in the cap to insert a large screw driver that can be used to pry the cap out of the cross bar. Remove any excess sealer that may remain in the end of the cross bar. Reassemble the boat. 2. The back rests are not interchangeable. There is a left side and a right side. Note that the forward end cap

Pin faces towards center. 2) With trampoline loosened, force hulls apart and place bow spreader in position on pins installed on bows 1 I I 3) With swivel cleat mounted to plate, install jib sheet jam cleat plate under existing trampoline hook* as shown. This is installed under center of three tramp hooks. Use the upper two of four holes in the plate. (*For installation on Club Wave see page two...) NOTE: Some very early model boats will require installation of an inspection port to access n

Drill a %" hold in the mast base as shown in figure A. Hobie 16 (older models with molded aluminum hook system). 1. Drill a %" hole as shown in figure B. 2. Remove hook by filing, leaving at least 3/16" of material around hole. 3. Drill head off press pin in mast step casting and remove with punch and hammer. 14 & 16: 1. Place bushing into narrow end of link. 2. Install link in mast step casting as shown in figure C. (There is an "up" arrow stamped into the left side of the link). 3. Tie

Thank you for purchasing a RadioShack Digital Vehicle Compass. Your compass conveniently provides accurate heading information inside your vehicle. It incorporates the same magnetic sensor technology that is used in factory-installed vehicle compasses. The compass electronically separates the Earth’s magnetic field from the magnetic fields generated by your vehicle, to provide accurate compass headings. Automatic Shut-Off — conserves power by turning off the compass about 10 minutes after you pa

The latch catches under the front center so this will ensure better sealing of the black o-ring seal. The key to bending the frame is compressing the yellow foam gasket as much as possible in the front middle and as little as possible in the sides by; 1) Making 4 side screws as loose as possible Step 1: Back off all four side screws (Figure 1) until they start to become slightly loose. 3) Get front 3 screws as tight as possible Step 2: Using a 5/32 drill bit, make a hole between the front s

The names Raytheon and RTN are owned by the Raytheon Company. ST40 Compass Instrument - quick reference guide Normal operation SWITCH ON t Compass heading Times out to the Compass heading screen after 5 seconds. o Locked heading Course computer sets auto lock Off course alarm values _Course computer sets auto lock ' Alarm on/off -+o 3 seconds Auto locked heading o -+- o Momentary :i>| alarm level 4+ o -I o i- With Set alarm level screen displayed, press the O and O