Assessments - 5, GPA: 3.6
(
)
)
|
Facilidade de uso
It consists of a metal enclosure and 12 Volt DC power supply/battery charger. It supplies 1 Amp continuous current and 2.5 Amps peak for the brief high current demands of the radio during transmission. The design of the enclosure allows quick and easy field mounting of the transceiver and antenna. FEATURES • Supplies 12 Volts D.C. Power for Transceiver • Current: 2.5A Peak, 1A Continuous • Heavy Duty Metal Enclosure INSTALLATION 1. Mount transceiver in top right corner by sliding antenna thru rubber grommet and securing the bottom using hardware supplied. (see page 2) 2. Mount the ELK-P624 power supply board into the enclosure as shown. 3. Wire as per the Cellular Transceiver instructions. 4. Connect Transformer and Battery after all wiring is complete. A OPERATION This hookup example shows the Transmission Shunt Mode of operation. Control panel's that have phone line fault monitoring will halt radio transmissions while the phone line is good. Relay contacts on the control panel will be closed to shunt any possible radio transmissions. If your control does not have line fault monitoring, see ELK-981 which provides line fault monitoring with power supply. * Note: Battery (ELK-1250) & Transformer (ELK-TRG1640) Included with ELK-982K Sold Separately for ELK-982 MIÜI >2Bll JP1[i JP2Ü Do Not Move Jumpers JP1 ON JP2 OFF О °' □eoeooo 0 9 0 0 Cellular Alarm Transceiver Refer to the Cellular Transceiver Instructions for Connections Transceiver Optional hookup Bell / Alarm 12 Volts D.C. for Transmission Input Power Input Shunt (if available) Control Panel Line Fault output Relay (contacts closed to halt radio transmissions) Bell I Alarm output LED Status Indicators (Grn)(Red) AC DC ON / ON OFF / ON Indication AC input is on / DC output is on. Normal. AC input is off / DC output is from Battery only. Step down Transformer is defective or unplugged, or the AC outlet is off. Battery will eventually discharge. ON /OFF AC input is on / DC output is off. The auto-reset overload protector is likely open due to an overload short circuit. OFF /OFF AC input is off / DC output is off. Red Black Battery 12 Volt See Note Features and Specifications subject to change without notice. For Technical Support on the Numerex Technologies Digicell Transceiver, call 888-987-5465. P.O. Box 100 • Hildebran, NC 28637 USA • 828-397-4200 • email: info@elkproducts.com 828-397-4415 FAX ELK PRODUCTS, INC. 03/04 Transceiver Mounting Location for this Model Circuit Board Area V Slide Transceiver Over Mounting Plate to Secure it in Place Place Antenna Grommet Here Q Place Plug Here Secure Mounting Plate Here Transceiver Mounting Location for this Model Circuit Board Area Secure Transceiver with Washer and Nut Here Place Place Antenna Grommet Here Plug Here Place Standoff Here...
Este manual também é adequado para os modelos :equipamento de barco - 982 (356.8 kb)