Assessments - , GPA: ( )

Instruções de Operação Attwood, Modelo 5310

Fabricante : Attwood
Arquivo Tamanho: 503.45 kb
Arquivo Nome : 69388-a-anti-glare-ar-light.pdf

Língua de Ensino:

O documento está colocado, por favor, espere

Baixe o seu Fechar

O documento está colocado, por favor, espere

Baixe o seu Fechar

A 03-02 This product carries the standard Attwood one-year warranty. See or Product Catalog for details. Lights meet USCG CFR 183.810, ABYC A-16 requirements, and all applicable standards as tested by Imanna Labs, 7/19/2002. 2 Nautical Mile visibility. Use Lamp 9235, #906 13V, 6 Candle Power. CAUTION: Read all instructions carefully before installing and using this product. All positive (+12V DC) lighting wires require a 1-amp fuse to protect circuits and vessel. The aluminum light pole is not grounded. MAKE SURE POWER SOURCE IS 12-VOLT DC ONLY. HIGHER VOLTAGE WILL DAMAGE LIGHT AND CIRCUITRY. WARNING: To prevent injury, disconnect power when installing or servicing this product. Remove boat from water before using any 120V AC power tools. LOCATION Anti-Glare All-Round Lights are designed for boats up to 39.4 feet (12m). Position the Anti-Glare All-Round Light so bulb is not less than one meter (39.4") above sidelights. If replacing an existing pole light, replace with a pole at least as long as the existing. Mount the anti-glare light in a position so that: • Light output is flat and parallel to water when boat is floating. • Light shines 360°, unobstructed. • Light does not shine on operator, or reflect off any part of the boat in the operator’s field of vision. Figure 1 7.5° or 39-3/8" One meter INSTALLATION Figure 2 Base #911339, 911370, or 911445 Pole Screw • Poles Without Locking Collar (5300 Series) 1. Align pole screw with slot in the existing base. Insert pole into base (Figure 2). 2. Press down firmly to engage electrical connectors. 3. To remove, pull straight up. Poles With Locking Collar (5310, 5320, 5330 Series) 1. Align pole screw with slot in the existing base. Insert pole into base (Figure 3). 2. Press down firmly to engage electrical connectors. 3. Slide locking collar down to base, rotate until you can insert lower ring inside top of base. 4. Press collar down into base and rotate until it tightens between pole and base. NOTE: Periodically check pole to make sure it is secure. loosens, then pull up on pole. (Figure 3) Figure 3 Locking Collar • Lower Ring • #91020, #91024, Screw • or #91026 #91022 TO CONVERT POLE FOR USE WITHOUT LOCKING COLLAR 1. For bases that do not accept locking collar, remove screw at bottom of pole. Slide locking collar off end of pole. 2. Replace screw in the upper screw hole. TO ADJUST ANTI-GLARE ARTICULATING HEAD (5330 Series) For best glare reduction, adjust the light while the boat is floating, or at the same attitude as if it were floating. 1. Unscrew lens counter-clockwise and remove. Remove bulb (Figure 4) 2. Remove the pivot screw. Pull the top pivot up and away from yoke. Place a small level on top of the socket and rotate to level position. 3. When it is level, push yoke and pivot back together. Replace and tighten screw. (Do not over tighten.) Replace bulb. Figure 4 Lens Off On Bulb #906 Pivot Screw OPERATION After installation, check lights to verify proper operation. Regu...