Distances at which RF radiation levels of 100 and 10 W/m2 exist are given in the table below. Note: If the scanner unit is installed at a close distance in front of the wheel house, your administration may require halt of transmission within a certain sector of scanner revolution. This is possible—Ask your FURUNO representative or dealer to provide this feature. Stay away from transmitting scanner. The radar scanner emits microwave radiation which can be harmful to the human body, particularly t

The target appears "pushed" or "pulled" near the picture center. The range to objects are shown at wrong distances. (1) Target pulled (2) Correct (3) Target pushed outward Examples of wrong and correct sweep timings 1. Transmit on the shortest range, then adjust the gain and the A/C SEA. 2. Visibly select a target that creates a straight line (harbor wall, straight piers). 3. Open the Installation menu and select Timing Adjust. 4. Press the ENTER key to show the setting window. 5. Press • or ..

30 m. • The output from a funnel or exhaust vent decreases aerial performance and hot gases can damage the radiator. The antenna unit must not be installed where the temperature is more than 55° C. • The antenna unit can be installed on the bridge, a common mast, or the radar mast. (c) Radar mast(b) Common mast (a) On bridge Installation procedure Refer to the outline drawing at the back of this manual for the dimensions. Make five holes in the platform. Four holes to fasten the antenna unit and

These units can be installed on a tabletop or flush mounted in a console or panel. 1.1.1 General mounting considerations • Keep the monitor unit out of direct sunlight. • Select a location where the unit(s) can easily be operated while observing the fishing ground or area surrounding the vessel. • For maintenance and checking purposes, leave sufficient space at the sides and rear of the unit and leave slack in cable. (Refer to the outline drawing at the back of this manual.) 1.1.2 Mounting Unibo

FURUNO Authorized Distributor/Dealer 9-52 Ashihara-cho, Nishinomiya 662-8580, JAPAN Telephone : 0798-65-2111 Fax : 0798-65-4200 All rights reserved. Printed in Japan FIRST EDITION : APR. 2003 G1 :OCT. 17, 2005 Pub. No. OME-72500 *00014698405* ( HIMA ) NAVPILOT-500 *00014698405* * 0 0 0 1 4 6 9 8 4 0 5 * *OME72500G10* *OME72500G10* * O M E 7 2 5 0 0 G 1 0 * SAFETY INSTRUCTIONS SAFETY INSTRUCTIONS WARNING Do not open the equipment unless you are well familiar with electrical circuits. Only qualifi

Otherwise the time required for complete “saturation” ill be lengthened and performance will be reduced. DO NOT paint the transducer. Performance will be affected. 28 4.4 Inside-hull Transducer The thru-hull mount transducer (520-5PSD, 520-5MSD) may also be installed inside the hull, following the procedure below. Necessary tools You will need the following tools: • Sandpaper (#100) • Silicone sealant • Silicone grease Remarks on installation • Turn off the engine and anchor the boat while insta

.. 1998 19981998 P PPr rrinte inteinted in J d in Jd in Ja aapa papan nn E2 E2E2 : :: JU JUJUL LL. .. 28, 28,28, 2006 20062006 P PPub. ub.ub. No. No.No. I IIM MME EE- --13030- 13030-13030-E EE2 22 A AAll r ll rll ri iig ggh hht tts r s rs re eese seser rrv vve eed dd. .. * **0 000080821301*0080821301* 0080821301* ( (( HI HIHIM MMA AA ) )) CH- CH-CH-37 * **3737 0 000080821301* 0080821301*0080821301* * ** 0 0 0 8 0 8 2 1 3 0 1 * 0 0 0 8 0 8 2 1 3 0 1 *0 0 0 8 0 8 2 1 3 0 1 * * **I IIME MEME1 11303

Tighten the knobs securely. CAUTION If the hanger vibrates too much from side to side, use the supplied rubber cushions to absorb the vibrations. CABLE CONNECTIONS Cable connections to the FE-4300 recorder unit are made at the connectors located at the rear of the unit. Fig. 11 shows the wiring instructions. 12 Transducer Cable Connection to Recorder Unit In order to minimize the chance of picking up electrical interference, avoid where possible routing the transducer cable near other on-

WIRING...............................................................................................2-1 2.1 Distributor Unit DS-610..............................................................................................2-2 2.2 Transceiver Unit DS-620 ...........................................................................................2-5 2.3 Display Unit DS-600, Remote Controller RD-501/Dimmer Controller RD-502 (option) ...............................................................

Navionics® is a trademark of Navionics®, registered in U.S. and other countries. Smart SensorTM is a trademark of AIRMAR, registered in U.S. and other countries. The future today with FURUNO's electronics technology. 9-52 Ashihara-cho, Nishinomiya City, Japan Phone: +81 (0)798 65-2111 Fax: +81 (0)798 65-4200, 66-4622 URL: Catalogue No. R-189a TRADEMARK REGISTERED MARCA REGISTRADA SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE FURUNO U.S.A., INC. Camas, Washington, U.S.A. FURUNO ESPANA S.A. Madr