Assessments - 3, GPA: 4.3
(
)
)
|
Facilidade de uso
21 FCC Information ............................................................................................ 22 Cleaning the Tape-Handling Parts ................................................................. 22 Specifications ..................................................................................................... 23 4 14-543.fm Page 5 Wednesday, June 30, 1999 3:52 PM PREPARATION Important: • Complete all connections to the CD-3319 before you connect it to power. • Be sure to follow all of the installation instructions described in the enclosed “Important Safety Instructions.” CONNECTING THE SPEAKERS Attaching the Speakers To attach the supplied speakers to the CD-3319, slide each speaker down into the grooves on each side of the CD-3319 until it clicks. To detach each speaker, press and hold the speaker’s locking latch away from the CD-3319, then lift the speaker straight up. Note: If you want to connect speakers other than the supplied ones, use speakers with an impedance of 4 ohms. Place the speakers so the distance between them is the same as the distance between the listening area and a point halfway between the speakers. If the distance between the speakers is greater, you can improve the stereo effect by angling the speakers in toward the listening area. To increase the bass effect, place the speakers in corners, against the wall, or directly on the floor. To decrease the bass effect, move the speakers slightly away from the wall, or raise them 6 or more inches off the floor. You can purchase speaker stands at your local Radio Shack store. 5 14-543.fm Page 6 Wednesday, June 30, 1999 3:52 PM Connecting the Speaker Wires Follow these steps to connect the speaker wires to the CD-3319. 1. Unwind as much speaker wire as you need from the back of each speaker, then slide the wire through one of the slots on the back of each speaker to hold it in place. 2. Insert the left speaker’s plug into SPEAKER L on the back of the CD-3319, then insert the right plug into SPEAKER R. Note: Be sure to match the positive side of the plug to the positive side of the terminal, and the negative side to the negative. 6 CONNECTING AN AUXILIARY AUDIO SOURCE To connect an auxiliary audio source to your CD-3319, such as a TV or VCR, plug the audio source’s left and right line level audio wires into AUX L (left) and AUX R (right). Set FUNCTION to AUX to select and listen to an auxiliary audio source. 14-543.fm Page 7 Wednesday, June 30, 1999 3:52 PM CONNECTING POWER You can power the CD-3319 from any of the following: • AC power using the supplied AC power cord • Nine D batteries (not supplied) • Vehicle battery power using a DCto- AC inverter (not supplied) Using AC Power To power the CD-3319 from standard AC power, plug the supplied AC power cord into the AC IN~ jack, then plug the other end into a standard AC outlet. Caution: The supplied AC power cord has a polarized plug that fits into the outlet only one way. If the plug does not fit properly, turn it over and try again. Do not force it. Note: The CD-3319 automatically disconnects internal batteries when you connect the AC power cord. Using Batteries You can power the CD-3319 from nine D batteries (not supplied). For the best results, we recommend alkaline batteries (such as Radio Shack Cat. No. 23550). 1. Press the two latches on the battery compartment cover and pull out the cover to remove it. 2. Place the nine D batteries in the compartment as indicated by the polarity symbols (+ and –) marked next to the battery compartment. Cautions: • Use only fresh batteries of the required size and type. • Never mix old with new batteries. • If you do not plan to use the batteries in the CD-3319 for a month or more, remove the batteries to protect the CD-3319 from possible battery leakage. 7 14-543.fm Page 8 Wednesday, June 30, 1999 3:52 PM 3. Replace the battery compartment cover. Cautions: • If the CD-3319 does not operate properly or if the sound weakens or distorts, replace the batteries. • Always dispose of the old batteries promptly and properly. • Never leave dead, old, or weak batteries in the CD-3319. They can leak chemicals and corrode or damage electronic circuits. Using Your Vehicle’s Battery You can power the CD-3319 from your vehicle’s battery using a DC-to- AC inverter (Cat. No. 22-132, not supplied). Cautions: • To protect your vehicle’s electrical system, always plug the AC power cord into AC IN~ and the inverter before you plug the inverter into the cigarette lighter socket. Always turn off the inverter and unplug it from the cigarette lighter socket before you unplug the AC power cord from AC IN~ and the inverter. • The recommended inverter supplies 120 volts AC power and delivers at least 315 milliamps. Using an inverter that does not 8 meet these specifications could damage the CD-3319. 1. Plug the supplied power cord into the AC IN~ jack on the back of the CD-3319. 2. Plug the AC power cord into the power inverter’s AC jack. 3. Plug the power ...
Este manual também é adequado para os modelos :Receptores - CD-3319 (212.53 kb)