Assessments - 4, GPA: 4.5
(
)
)
|
Facilidade de uso
Be sure to set the proper voltage in your area before use. (For details, please refer to the page 5.) Recording Recording (Deck 2 only)...............................................................10 Tape-to-tape recording.................................................................11 Accessories Please check and identify the supplied accessories. Reference Concerning cassette tapes.........................................................13 Maintenance.......................................................................................14 Technical specifications..............................................................14 Troubleshooting guide..................................................................15 2 Suggestions for safely Placement Avoid placing thi1 unit in areas of: • direct sunlight • high temperature • high humidity • excessive vibration • uneven surfaces (Place the unit on a flat level surface.) Such conditions might damage the cabinet and/or other component parts and thereby shorten the unit's service life. Stacking Never place heavy items on top of the unit or the AC power cord. Voltage • It is very dangerous to use an AC power source of high voltage such as for an air conditioner. A fire might be caused by such a connection. • A DC power source cannot be used. Be sure to check the power source carefully, especially on a ship or other place where DC is used. Power cord protection • Avoid cuts, scratches or poor connection of the AC power cord, as this may result in fire or electric shock hazard. Excessive bending, pulling or slicing of the cord should also be avoided. • Do not pull on the cord when you are disconnecting the power, as this could cause an electric shock. Grasp the plug firmly when you disconnect the power supply. • Never touch the plug with wet hands or a serious electric shock could result. • Ensure that no foreign objects, such as needles, coins, screwdrivers etc., accidentally fall into the unit. Otherwise, a serious electric shock or malfunction could occur. • Be extremely careful about spilling water or liquid on/into the unit, as a fire or electric shock could occur. (Disconnect the power plug and contact your dealer immediately if this occurs.) • Avoid spraying insecticides onto the unit as they contain flammable gases which can be ignited. • Insecticides, alcohol, paint thinner and similar chemicals should never be used to clean the unit as they can cause flaking or cloudiness to the cabinet finish. Service • Never attempt to repair, disassemble or reconstruct the unit if there seems to be a problem. A serious electric shock could result if you ignore this precautionary measure. • If a problem occurs during operation (the sound is interrupted, indicators fail to illuminate, smoke is detected, etc.) contact your dealer or Authorized Service Center immediately. • Disconnect the power supply if the unit will not be used for a long time. Otherwise the operation life could be shortened. CAUTION! DO NOT INSTALL OR PLACE THIS UNIT IN A BOOKCASE, BUILT IN CABINET OR IN ANOTHER CONFINED SPACE IN ORDER TO KEEP WELL VENTILATED CONDITION. ENSURE THAT CURTAINS AND ANY OTHER MATERIALS DO NOT OBSTRUCT THE VENTILATION CONDITION TO PREVENT RISK OF ELECTRIC SHOCK OR FIRE HAZARD DUE TO OVERHEATING. 3 Front panel controls © Power “STANDBY (I)/ON” switch (POWER, STANDBY O/ON) Press to switch the unit from un to standby mode or vice versa. In standby mude, the unit is stil! consuming a small amount of power. (2) Cassette holder for deck 1 (D “STANDBY” indicator (STANDBY) When the unit is connected to the AC mains supply, this indicator lights up in standby mode and goes out when the unit is turned on. © Remote control signal sensor This cassette deck can be operated by using the remote control provided with a Technics amplifier or receiver. (For detailed information, refer to the operating instructions of the amplifier or receiver.) (D Display © Cassette holder for deck 2 (7) Counter reset button (COUNTER RESET) ® Synchro-start button (SYNCHRO START) (9) Tape-to-tape recording-speed button ..........(SPEED, NOR/HI) ............ © Tape deck select button (DECK 1/2) .....^ ^ ! : K ....... ; fl:V OJ) Dolby noise-reduction button (DOLBY NR) 1111 © Reverse-mode select button (REVERSE MODE) .................. : . © Rec pause button (• REC PAUSE) @ Open button for deck 1 ( A OPEN) © Rewind/fast-forward buttons ( MM , ►► ) © Reverse-side playback button (4) © Stop button (■) © Forward-side playback button (►) © Open button for deck 2 ( A OPEN) Connections Hetoro making connections, make sure that tin1 power to this unit ,nii) ,i!l other system components is turned off first. Placements hints If this unit is placed near a receiver or a tuner, a "hum'' noise may be heard during tape playback, recording, or AM reception of the receiver or the tuner. If this occurs, leave as much space as possible between the un...