. The tape head is dirty. . Clean the tape head. . The speakers are not wired correctly. . Reconnect the speaker wires so that each output terminal is connected to a different speaker. ? The Touch Sensor Tone doesn’t sound. . The preout jack is being used. . The Touch Sensor Tone can’t be output from the preout jack. — 25 — English English ? Even though Synchronize be adjusted. . The received RDS station sending time data. . Receive another RDS Tuner source ? Radio reception is poor. . The car antenna is not extended. . Pull the antenna out all the way. . The antenna control wire is not connected. . Connect the wire correctly, referring to the section on . ? It isn't the set Traffic information sound volume. . The set sound volume is less than the tuner sound volume. . If the tuner sound volume is louder than the set sound volume,tuner sound volume is used. Disc source ? "AUX" is displayed without achieving External disc control mode. . O-N switch is set to "O" side. . Set the switch to "N" side. . Unsupported disc changer is connected. . Connect the supported disc changer. (page 3) ? The specified disc does not play, but another one plays instead. . The specified CD is quite dirty. . Clean the CD. . The CD is upside-down. . Load the CD with the labeled side up. . The disc is loaded in a different slot from that specified. . Eject the disc magazine and check the number for the specified disc. . The disc is severely scratched. . Try another disc instead. ? The specified track will not play. . Random play or magazine random play has been selected. . Turn off random play or magazine random play. ? Track repeat, disc repeat, track scan, random play, and magazine random play start by themselves. . The setting is not . The settings for these or the disc ejected, even changed. ? Cannot play CD-R or CD-RW. . Finalization processing is not being . Conduct finalization processing with . A non-compatible CD changer is being . Use a CD changer compatible with CD-R/CD-? Track Search can't be done. . For the albums first or last song. . For each album, Track Search can't be done in the backward direction for the first song or in the forward direction for song. If the following situations, consult your nearest center: • Even though the disc changer is connected, the Disc Changer source not ON, with "AUX" showing in the display during the Changer Mode. • Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the Auxiliary input is entered when switching modes. — 26 — Troubleshooting Troubleshooting EJECT: No disc magazine has The disc magazine is not . Load the disc magazine properly. NO DISC: No disc has been loaded in the . Load a disc into the disc magazine. E-04: No disc has been loaded in the disc magazine. . Load a disc into the disc magazine. The CD is quite dirty. The CD is upside-down. The CD is scratched a lot. . Clean the CD and load it correctly. BLANK: Nothing has been recorded on the MD. NO TRACK: No tracks are recorded on the MD, although it has a title. NO PANEL: The faceplate of the slave unit being connected to this unit has been removed. . Replace it. E-77: The unit is malfunctioning for some reason. . Press the reset button on the unit. If the "E- 77" code does not disappear, consult your nearest service center. E-99: The unit is malfunctioning for some reason. . Press the reset button on the unit. If the "E-99" code does not disappear, consult your nearest service center. HOLD: NO NAME: NO TITLE: NO TEXT: LOAD: 2 3 (Blink): The protective temperature inside exceeds 60°C (140° . Cool down the unit by turning on the air conditioner. As the temperature falls below 60°C (140°F), the again. Attempted to display DNPS during no disc names preset. Attempted to display the disc title or track the MD having no MD title is being played. Attempted to display the disc text or track text the CD having no CD text is being played. Discs are being exchanged in the Disc changer. The tape player section is not operating properly. . Reinsert the Tape. If the tape cannot be ejected or the display continues to flash even when the tape has been properly reinserted, please switch off the power and consult your nearest service center. — 27 — English English Specifications FM tuner section Frequency range (50 kHz ..............87.5 MHz – 108.0 Usable sensitivity (S/N = ................................. 0.7 .V/75 . Quieting Sensitivity (S/N = .............................. 1.6 .V/75 . Frequency response ( ± 3.0 dB) ..............................30 Hz – 15 Signal to Noise ratio (MONO) ..............................................65 Selectivity (DIN) ( ± 400 kHz)............................................. . 80 dB Stereo separation (1 kHz) ....................................................35 dB MW tuner section Frequency range (9 kHz Space) .....................531 kHz – 1611 kHz Usable sensitivity (S/N = 20dB) .....................
)
