Assessments - 3, GPA: 3.3
(
)
)
|
Facilidade de uso
The set should be placed to a position for the best reception. FM and FM stereo reception • Set the BAND switch to FM position, programmer is received in mono mode. NOTE: In particular when stereo signal is weak and much noise are received, it is preferable to receive the programmer in mono. • Many FM stations broadcast their programmes in stereo. When tuning in stereo broadcasts, the FM stereo indicator will light up automatically. Cassette recorder operation Cassette playback • Slide the FUNCTION switch to TAPE position. • Press the STOP/EJECT button to open the cassette compartment “A” or “B”. • Insert a cassette and push the cassette door to close the cassette compartment. • Press the PLAY button on desk “A” or “B” to start the playing. 3 NOTE: • Press the PAUSE button on desk “A” or “B” to pause the playing. • Press the STOP/EJECT button on desk “A” or “B” to stop the playing, press the button again to open the cassette door and you can take out the tape. • When the tape plays to the end, playing will be stopped automatically. Continuous playback • Slide the FUNCTION switch to TAPE position. • Insert two cassettes into desk “A” and “B”. • Press the PAUSE button and PLAY button on deck “A” simultaneously. • Press the PAUSE button and PLAY button on deck “B” simultaneously. • Press the PAUSE button again on deck “A”; it will play the tape. NOTE: • When the tape plays to the end on deck “A”, deck “B” will be playing automatically. • When the tape plays to the end on deck “B”, playing will be stopped automatically. Recording (deck “B” only) Tape to tape recording • Set the Function switch to TAPE position. • Insert a pre-recorded cassette into deck “A” and a blank cassette into deck “B”. • Press the PLAY button on deck “A”. • Press the PLAY button and RECORD button on deck “B” simultaneously to start recording at normal speed. NOTE: • Press the PAUSE button on deck “B” to pause the tape recording. • Press the STOP/EJECT button on deck “B” when the recording is finished. • Set the Dubbing Mode switch to HIGH position if you wish to activate high-speed copying function. This will reduce the recording time to about half. Recording from radio • Set the FUNCTION switch to RADIO position. • Tune to the desired station by turning the TUNING control regulator. • Insert a blank cassette into cassette compartment “B”. • Press the PLAY button and RECORD button on deck “B” simultaneously to start recording. 4 Recording from built-in condenser microphone • Slide the FUNCTION switch to TAPE position. • Insert a blank cassette into deck “B”. • Press the PLAY button and RECORD button on deck “B” simultaneously to start recording. NOTE: • The built-in condenser microphone used in this unit have very high sensitivity. Therefore, it is not necessary to place the radio cassette recorder close to the source of sound. Set the volume control to lower position during recording from built-in condenser microphone. Maintenance and care • Check your batteries regularly, old or discharged batteries should be replaced. If the unit is not going to be used for some time or is being run exclusively on the alternative power, remove the batteries to avoid leakage and damage. • Electron...