Assessments - 2, GPA: 4.5
(
)
)
|
Facilidade de uso
Temperature scale 10. Indicator light 11. Lock symbols 12. Crepe-/flat iron UK a. Ceramic plates b. Adaptor c. Lock ring USING THE APPARATUS Hair should be clean and dry when using the appliance. Fitting accessories 1. Turn the lock ring (c) until the arrow on the handle (7) is aligned with the black arrow on the lock ring. 2. Insert crepe iron/hair straightener (12), the narrow hair straightener (4) or one of the curling irons (1) in the socket in the handle and press firmly into place. 3. Turn the lock ring until the arrow on the handle is aligned with that on the lock ring. The accessory is now locked in place. Warming up 1. Place the appliance on a flat, heat-resistant surface, and plug it in (5). 2. Switch on by pushing the on/off switch (8) towards the white symbol (above). The indicator lamp (10) will light and remain on as long as the appliance is on. Setting the temperature The appliance has three setting as indicated on the temperature scale (9): o switched off (black symbol, botton) o medium temperature (black-white symbol, centre) o high temperature (white symbol, top) Temperature can be regulated by pushing the on/off button up and down. Using crepe-/flat iron Use the adapter (b) to change accessories such as flat- or crepe irons. o Make sure the crepe iron/hair straightener is switched off and push down the adaptor until the arrow is aligned with the two straight lines – the accessory is now a hair straightener. o Push the adapter up until the arrow is aligned with the two wavy lines – the accessory is now a crepe iron. o When the adapter is aligned with the dot in the middle the crepe-/flat iron is locked. Using the narrow hair straightener The narrow hair straightener is used as a separate hair straightener without an adaptor. It is used for smaller locks than the crepe iron/hair straightener. Using curling irons There are three different sizes of curling iron: The thinnest gives tight curls and the thickest loose curls. The larger the amount of hair treated at a time, the looser the curls will be. You can also make curls softer using the brush accessory (2) and coil accessory (3) (see below). Styling tips Brush hair thoroughly before setting. Divide your hair up into small sections, and deal with them separately piece by piece as described below until the desired result is achieved. Creped hair: o Start with a lock of hair about 5 cm wide and close the crepe iron’s ceramic plates (a) around the hair near the scalp. o Keep the plates closed for approx. 10 seconds. o Open the plates and close them again further along the lock of hair. Flat, smooth hair: o Start with a lock of hair about 5 cm wide (4 cm wide when using the narrow hair straightener) and close the accesory’s ceramic plates around the hair near the scalp. o Slowly slide the apparatus towards the hair ends in a fluent movement. Keep the hair tight to avoid kinks. For more lift in the hair, smooth only the outer part of the hair lock. Hair with a flick: o Start with a lock of hair about 5 cm wide. Hold the curling iron so that the jaw is at the reverse side of the lock and close the jaw close to the scalp. o Slide the apparatus slowly towards the hair ends. o Finish by curling the last piece of hair a little out at the ends. Hair with a curl: o Start with a lock of hair about 5 cm wide. Hold the curling iron so that the jaw is at the front of the lock and close the jaw close to the scalp. o Slide the apparatus slowly towards the hair ends. o Finish by curling the last piece of hair under at the ends. Curls: o Start with a lock of hair about 5 cm wide. Open the jaw at the curling iron and place it about halfway along the lock of hair. o Spread the hair along the cylinder and carefully release the upper jaw so that the hair is trapped. o Slide the apparatus slowly towards the hair ends. o Check hair ends are trapped under the jaw and finish by winding the lock around the curling tongs towards the scalp. Avoid touching the scalp with the hot curling tongs. o Hold the curling tongs in place for 5-8 seconds, depending on length and thickness of hair. o Open the jaw and remove the appliance from hair. Allow hair to cool before setting. Soft curls: o Attach the brush accessory on the thinnest curling iron without opening the jaw. Important: The iron must be cold when fitting the brush. o Heat the apparatus up. o Start with a lock of hair about 5 cm wide and roll it around the brush. Start at the hair ends and roll towards the scalp. o Hold the iron in place for approx. 10 seconds before carefully rolling the hair lock out again. Allow hair to cool before setting. Long curls: o Attach coil accessory to the thinnest curling iron (1) without opening the jaw. Important: The iron must be cold when fitting the coil. o Heat the apparatus up. o Start with a lock of hair about 5 cm wide and roll it around the spiral. Start at the hair ends. Trap them with the small jaw and roll towards the scalp. o Hold the iron in place for approx. 10 seconds bef...