Assessments - 2, GPA: 4.5
(
)
)
|
Facilidade de uso
Warning: The cutting line continues to rotate after the machine has been switched off. 360. 10m Electric Cable with moulded on plug Guard (with bolt and nut) Instruction Manual Adjustable Shoulder Harness Cable Management Cable Management Hexagon Drive Tool Handle Clamp Switch Handle Steady Handle Shoulder Harness Location Lock-off button 3. Do not use the product if the electric cables are non-slip footwear. damaged or worn. 5. Do not walk backwards when operating, you could 4. Immediately disconnect from the mains electricity sup-trip. Walk never run. ply if the cable is cut, or the insulation is damaged. 6. Keep cutting head below waist level. Do not touch the electric cable until the electrical sup-7. Never operate the product with damaged guards or ply has been disconnected. Do not repair a cut or without guards in place. damaged cable. Replace it with a new one. 8. Never fit metal cutting elements. 5. Your extension cable must be uncoiled, coiled cables 9. Keep hands and feet away from the cutting means at can overheat and reduce the efficiency of your product. all times and especially when switching on the motor. 6. Keep the cable clear of the cutting area and obsta-10. Never pick up or carry a product by the cable. cles at all times. 11. Do not lean over the trimmer guard - objects may 7. Do not pull cable around sharp objects. be thrown by the cutting line. 8. Always switch off at the mains before disconnecting 12. Remove the plug from the mains : any plug, cable connector or extension cable. -before leaving the product unattended for any period; 9. Never pull on the cable to disconnect any of the plugs. -before clearing a blockage; 10. Switch off, remove plug from mains and examine -before checking, cleaning or working on the appliance; electric supply cable for damage or ageing before -if you hit an object. Do not use your product until winding cable for storage. Do not repair a damaged you are sure that the entire product is in a safe cable, replace it with a new one. Use only Flymo operating condition; replacement cable. -if the product starts to vibrate abnormally. Check immediately. Excessive vibration can cause injury. 11. Always wind cable carefully, avoiding kinking. Maintenance and storage 12. Use only on AC mains supply voltage shown on the product rating label. 1. Keep all nuts, bolts and screws tight to be sure the product is in safe working condition. Under no circumstance should an earth be connect-2. Replace worn or damaged parts for safety. ed to any part of the trimmer. 3. Only use the replacement cutting line specified for Preparation this product. 13. Flymo trimmers are double insulated to EN60335. 1. While using your product always wear substantial 4. Only use replacement parts and accessories recomfootwear and long trousers. mended by Husqvarna Outdoor Products. 2. Before using the machine and after any impact, check 5. To avoid the risk of injury keep fingers and hands clear for signs of wear or damage and repair as necessary. of the line cutter on the leading edge of the guard. 3. Inspect the area to be cut before each use. Remove 6. Inspect and maintain the product regularly. Any all objects such as stones, broken glass, nails, wire, repairs must be carried out by an authorised repair- string etc, which can be thrown or become entan-er. gled in the trimmer head. 4. Check that the cutting head is fitted correctly. Use 1. Use the product only in daylight or good artificial light. 2. Avoid operating your product in wet grass, where feasible. 3. Take care in wet grass, you may lose your footing. 4. On slopes, be extra careful of your footing and wear Cables IMPORTANT Use only 1.00mm2 size cable up to 40 metres length maximum. Maximum rating: 1.00mm2 size cable, 10 amps 250 volts AC. YOUR PRODUCT IS SUPPLIED WITH AN ELEC TRIC MAINS CABLE WIRED DIRECTLY INTO THE PRODUCT. 1. Flymo Mains Cables and Extension Cables are available from your local Approved Service Centre. 2. Do not wire an extension cable directly to your product yourself. Please contact your local Approved Service Centre for further information on the connectors and kits available. 3. Only use extension cables specifically designed for outdoor use. CONNECTORS Flymo connectors are suitable for use with 2 core cable only. Under no circumstances should these connectors be used for earthed products. All Flymo connectors and cables are of splashproof construction. They are not waterproof and must not be left outside permanently nor should they be submerged or immersed in water. Do not let cable lay or trail through pools of water or splashed with water from hose pipes. MAINS PLUG REPLACEMENT • If the plug supplied is cut off it should be destroyed. There is an electric shock hazard if a cut off plug is inserted into a 13 amp socket. 1. No earth required. Flymo products are double insulated to EN60335 and under no circumstances should an earth be connected to any part of the product. 2. Ensure the mains voltage suits your ...