Assessments - 4, GPA: 4
(
)
)
|
Facilidade de uso
Some states do not allow the exclusion of incidental or consequential damages, so this exclusion may not apply to you. COPYRIGHT NOTICE All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. No patent liability is assumed with respect to the use of information contained herein. While every precaution has been taken in the preparation of this publication, Seiko Epson Corporation assumes no responsibility for errors or omissions. Nor is any liability assumed for damages resulting from the use of the information contained herein. Further, this publication and features described herein are subject to change without notice. TRADEMARKS Epson is a registered trademark of Seiko Epson Corporation. Equity is a trademark of Epson America, Inc. Centronics is a registered trademark of Centronics Data Computer Corp. Hercules graphic card is a trademark of Hercules Computer Technology. IBM is a registered trademark and AT and XT are trademarks of International Business Machines Corp. Microsoft, MS-DOS, and GW-BASIC are registered trademarks of Microsoft Corp. Copyright 1988 by Seiko Epson Corporation Nagano, Japan User’s Guide FCC COMPLIANCE STATEMENT FOR AMERICAN USERS This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Subpart J of Part 15 of FCC ru es,which are designed to provide l reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: l Reorient the receiving antenna l Relocate the computer with respect to the receiver l Move the computer away from the receiver l Plug the computer into a different outlet so that the computer and receiver are on different branch circuits. If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user may find the following booklet prepared by the Federal Communications Commission helpful: “Television Interference Handbook” This booklet is available from the U.S. Government Printing Office, Washington DC 20402. Stock No. 004-000-00450-7. Note: If the interference stops, it was probably caused by the computer or its peripheral devices. To further isolate the problem: Disconnect the peripheral devices and their input/output cables one at a time. If the interference stops, it is caused by either the peripheral device or its I/O cable. These devices usually require shielded I/O cables. For Epson peripheral devices, you can obtain the proper shielded cable from your dealer. For non- Epson peripheral devices contact the manufacturer or dealer for assistance. WARNING This equipment has been certified to comply with the limits for a Class B computing device, pursuant to Subpart J of Part 15 of FCC Rules. Only peripherals (computer input/output devices, terminals, printers, etc.) certified to comply with the Class B limits may be attached to this computer. Operation with non-certified peripherals is likely to result in interference to radio and TV reception. The connection of a non-shielded equipment interface cable to this equip ment will invalidate the FCC Certification of this device and may cause interference levels which exceed the limits established by the FCC for this equipment. User’s Guide User’s Guide Contents Introduction .................................. Intro-1 How to Use this Manual ......................... Intro-2 1 Setting Up Your System ........................ 1-1 Unpacking ..................................... 1-1 Removing the disk drive protector sheet ........... 1-2 Choosing a Location ............................. 1-2 Arranging the Components ....................... 1-3 The front panel ............................... 1-4 The back panel ............................... 1-5 Connecting the Power Cord ...................... 1-6 Connecting a Video Monitor ...................... 1-7 Connecting the Keyboard ........................ 1-9 Connecting a Printer ............................ 1-11 Parallel interface ............................... 1-11 Serial interface ................................ 1-12 The Equity II+ character set ..................... 1-13 Turning On the Computer ........................ 1-13 Safety rules .....................................