Assessments - 3, GPA: 3.3
(
)
)
|
Facilidade de uso
However, to ensure maximum performance and safety, it is important for you to observe certain precautions when using the cooker. Because the door on your cooker has been carefully designed to contain the microwave energy, the precautions below are important. PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY. Do not tamper with or attempt to defeat the safety interlocks which are operated by the door mechanism, or to make any irregular attempt to cause the cooker to operate with the door open. Do not place any object between the cooker front face and the door, or allow soil or cleaner residue to accumulate on sealing surfaces. IMPORTANT Ensure that the door-seal is cleaned and inspected regularly. It is particularly important that the door closes properly, and that there is no damage to the door, hinges and latches, door seals and door seal areas. If these areas are damaged, the appliance should not be operated until it has been repaired by a service technician trained by the manufacturer. It is dangerous for anyone other than a service technician trained by the manufacturer to perform repair service. Unauthorised service may make the guarantee void. 38 Contents Introduction and Installation 4 Features 5 Oven Introduction 6 Oven Control Display 6 Use of Oven Controls 7-18 Circulaire Fan-Oven Cooking 19 Oven Shelf Positions 20-21 Temperature Conversion Scale 22 Fan-Oven Temperature Charts 23-24 Grill 25 Use of Microwave Facilities 26-27 Combination Cooking 28 Roasting Chart 29 Microwave and Combination Cooking Precautions 30-31 Food Probe 32 Ceramic Hob 33-34 General Information Notes 35 Care and Cleaning 36-38 For details of spares, service and guarantee, see separate service leaflet 3 Introduction and Installation Creda appliances are guaranteed and will give lasting service. The Guarantee is only applicable if the appliance has been installed in accordance with the instructions packed with each unit. To help you make the best use of your Creda cooking equipment please read this booklet carefully. It should have been checked that the appliance voltage corresponds with your supply voltage, this is stated on the rating plate which can be seen when the drawer is opened. The cooker should be connected to a suitable 30 amp double-pole control unit adjacent to the cooker. IMPORTANT — For access to the mains terminal block, for supply cable connection, it is necessary to remove the access panel at the lower left hand comer of the rear panel (viewed from the rear). Under no circumstances should the rear panel itself be removed. No part of the appliance, even the timer of the oven unit, will operate unless the main control unit is switched On. When the cooker is first used a slight odour may be emitted by the oven lagging insulation — this should cease after a short period of use. Installation Note: WARNING:- THIS APPLIANCE MUST BE EARTHED. This appliance conforms to BS.800: 1983 and EEC directive 82/499 regarding suppression of radio and television reception interference. Height Adjustment The minimum height of the cooker will be set at 900mm to the top of the hob. This can be adjusted upwards to 915mm by rotating the two feet at the front and two screws at the rear of the plinth. Before sliding the cooker into position, measure the height from the floor to the top of adjacent units at the front and back and adjust the cooker height accordingly. This is best done by tilting the cooker sideways to gain access to the feet rather than by tilting forwards or backwards. May we wish you many years of carefree successful cooking and remember, our Customer Service department is always available to you for advice if you write to:— Customer Service Department CredaCare Building, Creda Works Blythe Bridge, Stoke-on-Trent ST11 9LN. Splash Back Panel A splash back kit is available as an optional extra and can be obtained from:— Creda Spare Parts Department CredaCare Building, Creda Works Blythe Bridge, Stoke-on-Trent ST11 9LN. Telephone: 0782 388300 4 Care and Cleaning Oven 1. Switch off mains supply. 2. Allow the oven to cool if necessary. 3. The shelf-hangers may be removed if desired, after unscrewing the two knurled screws near to the front of the oven. 4. Slight soiling may be removed by the use of a damp cloth wrung out in hot soapy water. Stubborn stains should be removed using a fine steel-wool pad, but do not use this on the central area of the oven roof* 5. Wipe dry with a clean cloth. 6. The hangers and shelves may be washed in hot, soapy water, using a fine steel-wool soap pad if necessary. 7. Replace hangers and shelves. 8. Switch on mains supply, and reset time-of-day on timer. IMPORTANT Do not use abrasive cleaners. Do not use aerosol cleaners, as they could adversely affect the fan motor unit, and cannot be wiped off the fan blade. *The central area of the oven roof is made from a microwave-transparent material. This is the “wind...