Log:
Assessments - 2, GPA: 3 ( )

Instruções de Operação Electrolux, Modelo Air-O-Steam 267552

Fabricante : Electrolux
Arquivo Tamanho: 895.32 kb
Arquivo Nome :
Língua de Ensino: en
Ir para baixar



Facilidade de uso


EPt3 - Probe sensor interrupted or short-circuited. EPt4 - Bypass sensor interrupted or short-circuited. EPt8 - Electronic controller temperature sensor damaged. ESCH - Malfunction of commands control circuit cooling devices. Etub - Boiler overtemperature (257°F)(125°C) warning. Etuc - Chamber overtemperature (608°F)(320°C) warning. EFLP - Fault in chamber steam discharge motor-operated valve. ETC - Tripping of chamber temperature limiter. ETB - Tripping of boiler temperature limiter. IMPORTANT! If an error code is displayed during a cooking cycle, the oven emits a continuous audible warning signal and the cooking cycle is interrupted. In this case the oven can be used only in cooking modes that do not involve the conditions that generated the error. Notify your Technical Service Center of the alarm code displayed. 6. SWITCHING OFF IN THE EVENT OF A FAULT If the appliance malfunctions, switch off as follows: • Disconnect the main circuit breaker of the appliance and close the water and gas valve. • Contact your authorized service company to perform maintenance and repairs. 7. CARE AND MAINTENANCE • At the end of each day clean the oven interior with an oven cleaner, following the product supplier's directions. • Do not wash the appliance with water jets. • Do not clean steel surfaces with products containing chlorine (bleach, hydrochloric acid etc.) even diluted. • Do not use corrosive substances (e.g. muriatic acid) to clean the floor under the appliance. The appliance has an automatic compartment cleaning programme called CLEANING SYSTEM; for its use see par. 1.4.3 USING PRESTORED PROGRAMMES for LEVEL A, whereas for LEVEL B and C see below. The CLEANING SYSTEM program uses detergent and rinse aid. Therefore, fill the DETERGENT container - max. 5 litres (on the RIGHT with RED cap) and the RINSE AID container - max. 1,2 litres (on the LEFT with BLUE cap) located under the control panel: RINSE AID _______________ __________DETERGENT max. 1,2 litres max. 5 litres Use the following cleaning products: - ECOLAB "Oven Cleaner Power" detergent (not in Gel). - ECOLAB "Oven Rinse Power" rinse aid (not in Gel). NB: Cleaning of the oven chamber is not ensured if a different type of detergent or rinse aid from that specified above is used. The oven features a UTILITY to perform a automatic or semiautomatic oven chamber cleaning cycle. Proceed as follows. In the level A oven, carry out the AUTOMATIC cleaning cycle by following the instructions in par. 4.4.6 CLEANING SYSTEM. ----------------- AUTOMATIC (C) ----------------- and SEMIAUTOMATIC (A-C) cycle 1) - Remove any large food remnants using a water jet. Do not use the spray shower or water jets to quickly cool the compartment and the inside glass of the oven door. 2) - Set the following UTILITY as described in heading 4.3.9 UTILITIES: 3) - Select one of the following wash cycles by turning the knob on the display TS: CLNT (semiautomatic) (level A-C) CLN1...2...3...4 (automatic) (level C) only for the description of these cycles see CLEANING SYSTEM in par. 4.4.6. 4) - Press the following button to confirm the selection 31 USA 5938 036 01 5) - Press the START/STOP button to start the cycle. ————— SEMIAUTOMATIC Cycle only (A-B-C) ————— The cycle will commence when the temperature automatically reaches 100 °C in the oven chamber. 6) - The 1st cleaning phase (STEAM cycle) ends after 5 minutes, as signalled by the audible alarm. 7) - Open the oven door and spray the surfaces to be cleaned with a suitable cleaning product. 8) - Close the oven door. On the TS DISPLAY the 120 second pass, to allow the degreasing agent to perform its action. At the end of the degreasing phase the 2nd cleaning phase (STEAM cycle) lasting 10 minutes starts, after which the alarm sounds (cycle finished). 9) - Open the oven door and rinse the interior of the chamber. To facilitate the oven chamber cleaning procedure, remove the guides for roll-in racks located at the bottom of the cooking chamber and open the air intake wall. • To open the cooking chamber air intake wall A (Fig. 2) follow these instructions: - switch off the oven and disconnect the appliance from the electrical power supply; - insert the tip of a screwdriver in opening B and pry inwards towards the oven (1) to open the side panel by disengaging it from the pins B1 at the back. To remove the air intake wall completely follow these instructions: - unscrew nut C1 with a hex wrench (2). - lift (3) the air intake wall to disengage it (4) from the lower pin C of the oven chamber; - lower (5) the wall to disengage upper pin D and then withdraw the wall completely (6). 2 To refit the air intake wall, repeat the steps in reverse order and retighten nut C1. • If present, clean the oven compartment grease filter (not supplied) at least every three cooking cycles. • If present, clean the air filter (not supplied) at least once a month, removing it from underthe control panel. Failure to clean the filter may affect its performance and impair c...

Este manual também é adequado para os modelos :
Fornos de microondas - Air-O-Steam 267554 (895.32 kb)
Fornos de microondas - 269554 (895.32 kb)
Fornos de microondas - Air-O-Steam 267550 (895.32 kb)
Fornos de microondas - Air-O-Steam 267553 (895.32 kb)

Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias