Log:
Assessments - 3, GPA: 4 ( )

Instruções de Operação Bosch, Modelo DS820IT

Fabricante : Bosch
Arquivo Tamanho: 395.85 kb
Arquivo Nome :
Língua de Ensino: en
Ir para baixar



Facilidade de uso


3.7 Snap the board into the base so the notch aligns with the tab. 3.8 Select LED operation. LED ON 7.5-9ft 7.5-9ft 7.5-9ft LED ON LED ON 7.5-9ft 7.5-9ft ON OFF 3.11 Walk test the detector. Perform this test at the time of installation and annually thereafter. 3.10 Microwave range is pre-set. Field adjustment is not required. NOTE: If you choose to adjust the range, set the adjustment as low as possible for proper catch performance. Be sure to walk test throughout the coverage pattern after any adjustment. 3.9 In non-pet applications only, if look-down is desired, peel away the look-down mask. Do not remove the clear plastic lens. LED ON 7.5-9ft 7.5-9ft INCREASE LED ON 7.5-9ft 7.5-9ft Peel away the mask 4.0 Coverage Patterns 5.0 FCC Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference, including interference that may cause undesired operation. Changes or modifications not expressly approved by Bosch Security Systems can void the user’s authority to operate the equipment. Although generally not required, the lens diagram shows the appropriate areas to be masked. Use an opaque material (such as, electrical tape) to mask the desired areas. 0 10 10 0 Feet 20 0 Meters 6 10 3 3 0 1 2 3 4 5 6 7 8 9 11 10 This detector contains an environmental stabilization circuit which requires approximately 2 minutes after initial power-up to warm up. During this time the detector will not respond to any movement. Please wait 2 minutes after initial power-up to perform any walk tests. Green = PIR detect Yellow = MW detect Red = Alarm DS820i Lens (inside view) 1 2 3 4 5 6 7 8 91011 12 22 23 33 34 44 45 55 56 66 67 77 Microwave Coverage PIR Coverage Microwave Coverage PIR Coverage 3.5 Mount the detector. NOTE: To avoid possible circuit board damage, use only the mounting hardware provided in the appropriate punch-out mounting holes. Do not use excessive force when adjusting the microwave pot. 0 0 0 20 6 10 3 Meters Feet 0 10 7.5 Look Down 67- 77 56- 66 45- 55 34- 44 23- 33 12- 22 1- 11 NOTE: Use only Limited Power Source up to 5 A maximum. Remove Don't overtighten the mounting screws Cover may not attach correctly Corner Mount Surface Mount Thinwall knockouts for wiring = 7.5 - 9 ft. (2.3 - 2.7 m) Areas if using the B335 Bracket Do not use the B335 Bracket in pet applications LED - + 6-15 VDC Alarm Contacts Tamper Contacts Normally Closed contacts (DS820iT only) ...

Este manual também é adequado para os modelos :
Fornos de microondas - DS820I (395.85 kb)

Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias