Log:
Assessments - 1, GPA: 3 ( )

Instruções de Operação Daewoo, Modelo KOR-61151

Fabricante : Daewoo
Arquivo Tamanho: 175.5 kb
Arquivo Nome : 9bbb7d87-17c9-47aa-b3b5-dd95fa1d205d.pdf
Língua de Ensino: en
Ir para baixar



Facilidade de uso


(b) Mark the following safety checks on all ovens to be serviced before activating the magnetron or other microwave source, and make repairs as necessary: (1) Interlock operation, (2) proper door closing, (3) seal and sealing surfaces (arcing, wear, and other damage), (4) damage to or loosening of hinges and latches, (5) evidence of dropping or abuse. (c) Before turning on microwave power for any service test or inspection within the microwave generating compartments, check the magnetron, wave guide or transmission line, and cavity for proper alignment, integrity, and connections. (d) Any defective or misadjusted components in the interlock, monitor, door seal, and microwave generation and transmission systems shall be repaired, replaced, or adjusted by procedures described in this manual before the oven is released to the owner. (e) A microwave leakage check to verify compliance with the Federal Performance Standard should be performed on each oven prior to release to the owner. TABLE OF CONTENTS PROPER USE AND SERVICE PRECAUTIONS 3 SPECIFICATIONS 4 FEATURE DIAGRAM 5 INSTALLATION 6 OPERATION 7 MEASUREMENT OF THE MICROWAVE OUTPUT POWER 8 MICROWAVE RADIATION TEST 9 KOR-6115 WIRING DIAGRAM 10 KOR-61151 WIRING DIAGRAM 11 CIRCUIT DESCRIPTION 12 PRECAUTIONS FOR DISASSEMBLY AND REPAIR 14 DISASSEMBLY AND ASSEMBLY 15 INTERLOCK MECHANISM 20 TROUBLE SHOOTING GUIDE 22 COMPONENT TEST PROCEDURE 24 EXPLODED VIEW AND PARTS LIST 26 2 PROPER USE AND SERVICE PRECAUTIONS CAUTION : THIS DEVICE IS TO BE SERVICED ONLY BY PROPERLY QUALIFIED SERVICE PERSONNEL. CONSULT THE SERVICE MANUAL FOR PROPER SERVICE PROCEDURES TO ASSURE CONTINUED SAFETY OPERATION AND FOR PRECAUTIONS TO BE TAKEN TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY. 1. For Safe Operation Damage that allows the microwave energy (that cooks or heats the food) to escape will result in poor cooking and may cause serious bodily injury to the operator. IF ANY OF THE FOLLOWING CONDITIONS EXIST, OPERATOR MUST NOT USE THE APPLIANCE. (Only a trained service personnel should make repairs.) 1) A broken door hinge. 2) A broken door viewing screen. 3) A broken front panel, oven cavity. 4) A loosened door lock. 5) A broken door lock. The door gasket plate and even cavity surface should be kept clean. No grease, soil or spatter should be allowed to build up on these surfaces or inside the oven. DO NOT ATTEMPT TO OPERATE THIS APPLIANCE WITH THE DOOR OPEN. The microwave Oven has concealed switches to make sure the power is turned off when the door is opened. Do not attempt to defeat them. DO NOT ATTEMPT TO SERVICE THIS APPLIANCE UNTIL YOU HAVE READ THIS SERVICE MANUAL. 2. For Safe Service Procedures 1) If the oven is operative prior to servicing, a microwave emission check should be performed prior to servicing the oven. 2) If any certified oven unit is found to have excessive emission level 5mW/cm2, the service person should: (a) inform the manufacturer, importer or assembler, (b) repair the unit at no cost to the owner, (c) attempt to ascertain the cause of the excessive leakage, (d) tell the owner not to use the unit until the oven has been brought into compliance. 3) If the oven operates with the door open, the service person should tell the user not to operate the oven and contact the manufacturer immediately. CAUTION MICROWAVE RADIATION PERSONNEL SHOULD NOT BE EXPOSED TO THE MICROWAVE ENERGY WHICH MAY RADIATE FROM THE MAGNETRON OR OTHER MICROWAVE GENERATING DEVICE IF IT IS IMPROPERLY USED OR CONNECTED. ALL INPUT AND OUTPUT MICROWAVE CONNECTIONS. WAVEGUIDES, FLANGES AND GASKETS MUST BE SECURE. NEVER OPERATE THE DEVICE WITHOUT A MICROWAVE ENERGY ABSORBING LOAD ATTACHED. NEVER LOOK INTO AN OPEN WAVEGUIDE OR ANTENNA WHILE THE DEVICE IS ENERGIZED 3 SPECIFICATIONS ITEM SPECIFICATION POWER SUPPLY 120V~60Hz, SINGLE PHASE WITH EARTHING MICROWAVE POWER CONSUMPTION 920 W OUTPUT POWER 600 W (IEC 705) (FULL MICROWAVE POWER) FREQUENCY 2450 MHz OUTPUT DIMENSIONS (W X H X D) 465 X 274 X 360 mm (18.3 X 10.8 X 14.2 in.) CAVITY DIMENSIONS (W X H X D) 290 X 200 X 290 mm (11.4 X 7.9 X 11.4 in) NET WEIGHT APPROX. 12.5 kg (27.6 Ibs.) TIMER 35 min. DUAL SPEED POWER SELECTIONS 5 LEVELS CAVITY VOLUME 0.64 Cu.Ft. *Specifications are subject to change without notice. 465 360 274 4 FEATURES DIAGRAM 2 41 9 12 11 8 35 6 7 ¤ Safety Interlock System ¤LDoor Viewing Screen - Allows viewing of food. The screen is designed so that light can pass through, but not the microwave. ¤ODoor Hook - When the door is closed, it will automatically shut. If the door is opened while the oven is operating, the magnetron will immediately stop operating. ¤OEOven Cavity ¤.Door Seal - Door seal maintains the microwave energy within the oven cavity and prevents microwave leakage. ¤ Glass Cooking Tray - Made of special heat resistant glass. Food in a proper receptacle is placed on this tray for cooking. ¤ Roller Guide - This must always be used for cooking together with the glass cooking tray. ¤ Coupler - This fits over the...

Este manual também é adequado para os modelos :
Fornos de microondas - KOR-61155 (175.5 kb)

Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias