Assessments - 2, GPA: 5 ( )

Fabricante : Hamilton Beach Arquivo Tamanho: 384.42 kb Arquivo Nome : Língua de Ensino:

If the strips become bent back, they can be unbolted and turned around to improve clean out. Upper Auger Knives can be turned over for use of a new cutting edge and should be periodically sharpened, or replaced if they are no longer sufficiently breaking up material. Lower auger knives can be rotated several times before sharpening or replacement is required. Motor fan guard must be kept clean to allow sufficient air flow for proper motor cooling. Drive belts must be checked for wear and hardness. Old belts will be brittle or hard and must be replaced. Pulley misalignment often causes belt wear and this alignment should be checked when replacing any worn belt. Inspect pulleys for wear or damage both on the grooves and on the shaft diameter, clean and dry thoroughly before reassembly. Tighten belts to a tension that will allow the belt to deflect 1/2” when a 10lb. force is applied in the middle of the belt span. Belts should be kept clean, dry and oil free. IMPORTANT: WHEN WELDING ON THIS UNIT: Do Not allow the current to flow through the bearings, roller chains, or scale weigh bars. Ground directly to the item being welded. ALWAYS disconnect weigh bar cords from scale indicator before welding. 23 3000STOPR005810R082503 KUHN KNIGHT INC. 1501 West 7th Ave. Brodhead, WI 53520-0167 701 Cherry Ave. Greeley, Co. 80632 INSPECTION & ADJUSTMENTS: Electronic Scale (optional) Scale Indicator: Refer to the electronic scale operators manual for adjustment information. The operator’s manual for the Electronic Scales should be kept with this manual. Additional scale manuals may be obtained through Kuhn Knight Inc. Load cells and weigh bars should be kept clean, dry & lubricated to insure dependability. Normal scale activity: Some warm up scale drift may occur after the scale is turned on but should zero balance within 10-15 minutes. Scale may zero shift over night due to temperature changes. Weight may change slightly due to terrain changes when mixer is moved. Vertical check bolts must not be tight (and should be free to rotate by hand) and need not less than 1/16” and no more than 3/32” free play when properly adjusted on level ground. Check arm assembly must be free to slightly rotate by hand when mixer is on level ground (see diagram), with mounting bolts tight. PIN CHECK BEARING should be centered on the pin when mixer is on level ground. Adjustment can be made by loosening the mounting bolts, centering pin check assembly on the pin and tightening the mounting bolts. If bushing cannot be centered load cells may require adjustment. INSPECTION & ADJUSTMENTS ALWAYS STOP MIXER AND LOCK OUT POWER BEFORE SERVICING, REPAIRING, OR CLEANING. IF WORK MUST BE PERFORMED INSIDE THE MIXER, STOP MIXER AND LOCK OUT POWER AND PUT A PROTECTIVE COVER OVER THE AUGER KNIVES TO AVOID INJURY. THE HOPPER FLOOR MAY BE SLIPPERY, AND THE REEL AND AUGERS WILL SPIN WHEN STEPPED ON. USE CAUTION WHEN STEPPING OR STANDING INSIDE THE UNIT. USE SAFE SHOP PROCEDURES AND EXERCISE CAUTION WHE...

Baixe o seu

Para fazer o download, introduza 2 dígitos :