Assessments - 2, GPA: 3.5 ( )

Fabricante : Karcher Arquivo Tamanho: 295.9 kb Arquivo Nome : Língua de Ensino:

See accessories order form for product descriptions and ordering instructions. 1 Dirtblaster® nozzle 1 Extension Wand 80” 1 Rotating Wash Brush 1 Sand Blasting Attachment Hose Reel Pipe Drain Cleaner Extension Hose 30' Detergent Tray In USA Call: 1-800-537-4129 or visit our website: TROUBLESHOOTING Symptom Cause Solution Engine will not start. No gasoline. Fill gas tank. Low oil level sensor activated. Add oil. Fuel valve is in “OFF” position. Slide the fuel valve lever to “ON” position. Engine throttle is not in correct position. Slide the throttle left 1/3 of the way to the fast position. Choke is not in correct position. Slide choke lever left to closed position. Pressure built up in the high pressure washer. Squeeze the trigger to release the pressure. Engine switch in “OFF” position. Turn engine switch on. Unit does not reach high pressure. Diameter of garden hose is too small. Replace with a 3/4 inch garden hose. Water supply is restricted. Check garden hose for kinks, leaks and blockage. Not enough inlet water supply. Open water source full force. Water inlet filter is clogged. Remove filter and rinse out in warm water. Pump pressure control is in low pressure position. Turn pump pressure control to high pressure position. Black detergent nozzle is attached. Remove black detergent nozzle and attach a high pressure nozzle. Output pressure varies high and low. Not enough inlet water supply. Turn water on full force. Check garden hose for kinks, leaks or blockage. Pump is sucking air. Check that hoses and fittings are air tight. Turn off machine and purge pump by squeezing trigger gun until a steady flow of water emerges through the nozzle. Water inlet filter is clogged. Remove filter and rinse out in warm water. Discharge nozzle is obstructed. Blow out or remove debris with a fine needle. Calcified gun, hose or spray wand. Run distilled vinegar through detergent suction tube. TROUBLESHOOTING - continued Symptom Cause Solution No detergent. Detergent suction tube not properly connected to the machine. Check connection. Detergent is too thick. Dilute detergent. For best results, use Karcher detergent. Detergent filter valve is at lowest setting. Set detergent filter valve to a higher setting. Filter on detergent suction tube is clogged. Run warm water through filter to remove debris. Damaged or clogged detergent suction tube. Remove obstruction or replace detergent suction tube. A high pressure nozzle is attached. Replace with black detergent nozzle. Discharge nozzle is obstructed. Blow out or remove debris with fine needle. Garden hose connection leaks. Loose fittings. Tighten fittings. Missing/worn rubber washer. Insert new washer. Spray wand leaks. Spray wand not properly attached. Slide the spray wand into the gun. Turn the wand collar clockwise onto the gun threads until tight. Broken o-ring. Call Karcher customer service hotline and order an o-ring. Pump is noisy. Pump is sucking air. Check that hoses and fittings are air tight. Turn off machine and purge pump by squeezing trigger gun until a steady flow of water emerges through the nozzle. Water leaks from pump. Loose fittings. Check that all fittings are tight. Water seals are damaged or worn. Call service center. Thermal protection device is activated. Thermal protection device will auto reset. Oil Drip. Oil seals are damaged or worn. Call service center. If you encounter any additional difficulties not listed, please call our service center for help. Karcher Customer Support USA In USA Call: 1-800-537-4129 or visit our website: www.karcher-usa.com...

Baixe o seu

Para fazer o download, introduza 2 dígitos :