DO NOT smoke or work near open flames while performing maintenance. To ensure efficient operation and longer life of your pressure washer, a routine maintenance schedule should be prepared and followed. If the pressure washer is used in unusual conditions, such as high-temperatures or dusty conditions, more frequent maintenance checks will be required. D30339 D30339D30339D3033914- ENG CUSTOMER RESPONSIBILITIES TABLE MAINTENANCE TASK Before each use Every 25 hours or yearly Every 50 hours or year

F. This can cause extensive damage to this unit. If unit has to be stored under freezing conditions a nontoxic R.V. anti-freeze should be put in the pump according to steps below to protect from freezing. • Be sure engine switch is in “OFF” position and spark plug wire has been removed from spark plug. • Pull the trigger on the spray gun to release the pressure in the high pressure hose. Detach high pressure hose and garden hose from the unit. • Pull the recoil on the engine 4 to 6 times to disc

EPA and B&S are pleased to explain the Emission Control System Warranty on your 1996 and later utility or lawn and garden equipment (ULGE) engine. In California, new ULGE engines produced on or after August 1,1995 must be designed, built and equipped to meet the State’s stringent anti-smog standards.» Elsewhere in the United States, new non-road, spark-ignition engines certified for model year 1997 and later, must meet similar standards set forth by the U.S. EPA. B&S must warrant the emission co

PART NO NO DESCRIPTION REF NO PART NO DESCRIPTION REF N0. PART NO DESCRIPTION 95 94098 Screw (Throttle Valve) 97 493267 Throttle Shaft 104 «691242 Float Hinge Pin 117 494870 Main Jet 497315 Main Jet (High Altitude) (Used After Code Date S6060200) 496495 Main Jet -------Note-----I 498254 Carbureter 125 498170 497348 Main Jet (High Altitude) (Used Before Code Date 95103000) Carburetor (Used After Code Date 96060200) 127 • 130 591203 133 398137 134 «398188 137 »♦ 163*«*2726

Do not overfill. Wipe up spilled fuel before starting the engine. Refer to engine manual for correct procedure. 2. Check engine oil level. See Engine Operators Manual for correct procedure. NOTE: There will be a slight amount of oil in the engine from factory testing. 3. Verify the filter screen is in water inlet of pump. NOTE: Cone side faces out. 4. Connect water source to pump inlet. NOTE: Water source must provide a minimum of 5 gallons per minute at 20 p.s.i. 5. Connect high pressure hose t

plate is located on the frame. Record these numbers in the spaces below and retain for future reference. Model No. Type Serial No. Part No. D26052-023-0 BEFORE ASSEMBLY 1. Shut off the pressure washer and turn off the water supply. 2. Pull trigger on gun handle to relieve any water pressure. 3. Disconnect the high pressure hose from the gun. TO ASSEMBLE HOSE REEL 1. Attach handle to flange assembly. NOTE: Screws must be inserted from the inside of hose reel and secured with nuts on the outside a

. For the location of the nearest Authorized Warranty Service Center call 1-888-559-8550, Ext. 2, 24 hours a day, 7 days a week or visit our web site @ devap.com. . All pressure washers carry a manufacturer's one year warranty from date of purchase for consumer use and a 90 day warranty for commercial use. . Retain sales receipt as proof of purchase for warranty service. 5 — ENG D22885 BOX CONTENTS Handle Engine Manual Engine Frame and Wheel High Pressure Hose Assembly Bagged Handle Chemical Hos

A new spark plug 8. Purge pump of air and contaminants. and clean air filter assure proper fuel-air mixture and help your engine run better and last longer. if equipped with inflatable tires, keep the air pressure at the value marked on the tire or within 15 and 40 psi. 13 PRESSURE WASHER C_ean Debris Daily or before use, clean accumulated debris from pressure washer. Keep linkage, spring and controls clean. Keep area around and behind muffler free from any combustible debris. Pressure washer pa

-Fri. 8 a.m. to 5 p.m. (CT) ®AssembJy ®Operation ADV =RT = CIA ,, Maintenance Beforeusingthisproduct,readthis Antesdeutiiizareiproducto,ieaeste manuatandfoiiow aliSafetyRuIes manuaiysigatodaslasRegIasde ®Parts and Operating instructions= Seguridade instrucciones de Uso= ,, Espa_oi, p. 34 Sears, Roebuck and Co., Hoffman Estates, [L 68179 U.S.A. Visit our Craftsman website: Part No. 203771GS Draft -(04/18/2007) WARRANTY.......................................... SAFETYRULES.........................

8 a.m. to 5 p.m. (CT) CAUTION: Before using this product, read this manual and fotlow ati Safety Rules and Operating [nstructionso " , o Assembmy Operation Maintenance Parts EspaSol SEARS, visit our ROEBUCK and Craftsman website: CO., Hoffman Estates, IL 60179 U.S.A. Part No 194190 Draft 4 (05/04/2004) 98 WARRANTY .................................... 2 STORAGE .................................. 16-17 SAFETY RULES ............................... 2-4 NOTES ................................... 18 &