Assessments - 4, GPA: 3.8
(
)
)
|
Facilidade de uso
3M Touch Systems Proprietary Information CHAPTER 3 Video Display Options This chapter provides guidelines for adjusting the video display and using the monitor controls to adjust the image to your liking. Before you make any adjustments: • Be sure to adjust the controls in your normal lighting conditions. • Display a test image or pattern whenever you adjust the video. Adjusting the M150 Video Display Your M150 FPD monitor has four controls to adjust the video display. • MENU . Shows or hides the menu. • SELECT -- Highlights the current menu option or saves the current setting. Press > or < to change the value. • /Right -- Enables you to scroll forward through items on the menu -- increase the value of selected option or move to the next menu item. If you do not press the Menu, Select, or /right adjust buttons for 45 seconds, the monitor adjustment program times out and hides the menu options. You can press the Menu button at any time to display the options again. 3M Touch Systems Proprietary Information M150 FPD Monitor Installation Guide Pressing MENU will pull up the On Screen Display (OSD) menu, as shown below. Figure 9 M150 Main Menu Options Auto Bright Contrast Color Position Image Misc Config Auto Config To perform an Auto Config, press the /right arrow buttons, and press SELECT to confirm the new setting. Contrast Selecting the Contrast option will allow you to adjust the contrast of the display. Adjust the contrast using the /right arrow buttons, and press SELECT to confirm the new setting. Color When you choose the Color option from the OSD, this will bring up a submenu that will allow you to adjust the RGB or Black Level color balance for your display. Use the /right arrow buttons to scroll through the color menu. By adjusting a single color, you can make the picture look warmer (biased towards red) or cooler (biased towards blue). Adjusting all three levels will make colors appear more or less striking. 3M Touch Systems Proprietary Information M150 FPD Monitor Installation Guide Position You can use the Position option to center the image on the display manually. Use the /right arrow buttons to scroll through the position menu. • H-Position is used to adjust the horizontal image position manually. • V-Position is used to adjust the vertical image position manually. Image Use the /right arrow buttons to scroll through the image menu. Phase: If the phase of your monitor is not fine-tuned, you may observe unstable horizontal noise lines and cross-talk stretching from the edge of small windows on your display. If you change your display to Windows shut down mode, this noise will be more visible, and easier to eliminate. Click on the "Start" button at the bottom right side, and then click Shut Down. This will bring you to the Windows shutdown mode. After finishing phase adjustment, click on the "Cancel. to return to your original Windows display. Clock: If the clock setting of your image is not fine-tuned, you may observe periodic vertical bars of video noise on your image. These bars of noise are usually adjusted out when an Auto Configuration is performed. If the bars of noise are still present, this setting can be adjusted manually. 3M Touch Systems Proprietary Information Chapter 3 Video Display Options Adjust this setting so that either the vertical bars of noise are replaced by an even amount of noise across the whole screen, or the noise disappears completely. If you do an Auto Config, the monitor will try to find the best Clock/Phase se...