Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
according to the European guideline 2002/96/EC on waste electrical and electronic equipment – WEEE. The directive specifies the framework for an EU-wide valid return and re-use of old appliances. a= Warning Redundant appliances 1. Pull out the mains plug. 2. Cut off the power cord and discard with the mains plug. 3. Do not take out the trays and receptacles: children are therefore prevented from climbing in! 4. Do not allow children to play with the appliance once it has spent its useful life. Danger of suffocation! Refrigerators contain refrigerant and gases in the insulation. Refrigerant and gases must be disposed of professionally. Ensure that tubing of the refrigerant circuit is not damaged prior to proper disposal. Scope of delivery After unpacking all parts, check for any damage in transit. If you have any complaints, please contact the dealer from whom you purchased the appliance or our customer service. The delivery consists of the following parts: ¦ Built- in appliance ¦ Interior fittings ( depending on model) ¦ Bag containing installation materials ¦ Operating instructions ¦ Installation manual ¦ Customer service booklet ¦ Warranty enclosure ¦ Information on the energy consumption and noises en Room temperature, ventilation and cavity depth Ambient temperature The appliance is designed for a specific climate class. Depending on the climate class, the appliance can be operated at the following temperatures. The climate class can be found on the rating plate. Fig. 8 Climate class Permitted ambient tempera ture SN +10 °C to 32 ° C N +16 °C to 32 ° C ST +16 °C to 38 ° C T +16 °C to 43 ° C Note The appliance is fully functional within the room temperature limits of the indicated climatic class. If an appliance of climatic class SN is operated at colder room temperatures, the appliance will not be damaged up to a temperature of +5 ° C. Ventilation The air on the rear panel of the appliance heats up. Conduction of the heated air must not be obstructed. Otherwise, the refrigeration unit must work harder. This increases power consumption. Therefore: Never cover or block the ventilation openings! Cavity depth A cavity depth of 560 mm is recommended for the appliance. If the cavity depth is smaller – at least 550 mm – the energy consumption increases slightly. Installation location Install the appliance in a dry, well ventilated room. The installation location should neither be exposed to direct sunlight nor near a heat source, e. g. a cooker, radiator, etc. If installation next to a heat source is unavoidable, use a suitable insulating plate or observe the following minimum distances to a heat source: ¦ 3 cm to electric or gas cookers. ¦ 30 cm to an oil or coal- fired cooker. Connecting the appliance After installing the appliance, wait at least 1 hour until the appliance is switched on. During transportation the oil in the compressor may have flowed into the refrigeration system. Before switching on the appliance for the first time, clean the interior of the appliance ( see chapter “ Cleaning the appliance”) . Electrical connection The socket must be near the appliance and also freely accessible following installation of the appliance. The appliance complies with the protection class I. Connect the appliance to 220–240 V/50 Hz alternating current via a correctly installed socket with protective conductor. The socket must be fused with a 10 to 16 A fuse. For appliances operated in non- European countries, check whether the stated voltage and current type match the values of your mains supply. This information can be found on the rating plate. Fig. 8 en Getting to know your appliance Please fold out the illustrated last page. These operating instructions referto several models. The features of the models may vary. The diagrams may differ. Fig. 1 1- 5 Controls 6 Freezer shelf 7 Frozen food container Controls Fig. 2 1 Temperature controller Is used to set the freezer compartment temperature. 2 On/Off button Serves to switch the whole appliance on and off. 3 “super” button Switches super freezing on and off. Illuminates when super freezing is on. 4 Alarm button Used to switch off the warning signal, see chapter “ Alarm function”. en 5 Alarm display Lights up if the freezer compartment becomes too warm. It goes out when the freezer compartment has reached the set temperature. Switching the appliance on Fig. 2 Press the On/ Off button 2, the button is lit. The temperature alarm is switched off by pressing the alarm button 4. The alarm display 5 lights up until the appliance has reached the set temperatures. We recommend the medium setting. Operating tips ¦ The sides of the housing are sometimes heated slightly. This prevents condensation in the area of the door seal. ¦ If the freezer compartment door cannot be immediately re-opened after it has been closed, wait until the resulting low pressure has equalised. ¦ The refrigeration system may cause several areas of the freezer shelves to frost quickly. This does not...
Este manual também é adequado para os modelos :Freezers - GF18DA60/03 (1.91 mb)
Freezers - GI14DA65/03 (1.91 mb)