Assessments - 2, GPA: 4
(
)
)
|
Facilidade de uso
A seperate gain control is supplied for comfortable headphone volume. SLIDE TYPE gain controls for each turntable to eliminate "center dead spot" in conventional pan controls. FRONT PANEL Headphone jacks for user convenience. SOLID STATE circuitry employing the most modern 1C state of the art design. MIXJER SECTION allows use of two turntables, two recorders, two mike preamplifiers or any of these combined. Specifications: MIXER SECTION INPUTS: (per channel, except as noted) PHONO: Sensitivity; 2.5 millivolts Passive circuitry avoids transistor noise Input impedance; 50K ohms Signal to Noise; 70 dB MIXER DOES NOT EFFECT RIAA equalization; OUTPUTS: HEADPHONE (MONO): Monitors 'Phono-1' or 'Phono-2' input before faders, with 'cue' control. OUTPUT 5V RMS (Max) into 100 ohms (will accommodate any headphone impedance from 8 ohms up; output impedance 47 ohms). FREQUENCY RESPONSE: Flat DC to 30 KHZ INPUT OVERLOAD CHARACTERISTICS: PHONO: 300 millivolts, RMS DIMENSIONS: 11' (W) 9” (H) 3%" (D) SHIPPING WEIGHT: 5 lbs. The Gemini Stereo Disco Mixer is plugged directly to the Phono input of your present amplifier. The inputs marked 1 and 2 on the back, are for turntables fitted with stereo cartridges. Connect turntable 1, left and right respectively, and likewise for turntable 2. The output is then connected to the Phono input of your amplifier. Input level slide controls marked 1 and 2, are for adjusting levels and mixing turntables 1 and 2, respectively. The Monitor allows the user to monitor the right channel of either turntabk 1 or 2, independently of the turntable gain controls and has its own gain control to adjust headphone volume. CD gemini DISCO MIXER MODEL DAC X-1DQD CD 0 CUE l-г POWER О ° -Щ (-QFF 0 -10 10- T T T 0 HEADPHONE CUE LEVEL PHONO 1 phono г CD CD OPERATING INSTRUCTIONS CONNECTIONS: Use our illustrated diagram as a helpful guide to setting up your disco system. HEADPHONE: The headphone jack and cue switch are located on the front panel. TURNTABLE CONNECTIONS: Connect turntable 1 output leads to phono 1 input jacks on rear panel of mixer. Follow same for turntable 2. Connect both turntable ground wires to ground terminal on rear of mixer. AMPLIFIER: Connect the output on the rear panel of the mixer with shielded stereo cables to an amplifier phono input jack. STEREO DISCO MIXER THIS MIXER ENABLES THE USER TO MIX TWO TURNTABLES FOR A PROFESSIONAL DISCO SOUND. GROUND CABLE GROUND CABLE REAR PANEL FRONT PANEL gemini rv y? :eT ! / HIADPhûNt CUC LÍVEL PHONO 2 Connect right and left output cables from Phono 2 to respective Phono 2 input jacks on rear of Disco Mixer PHONO 1 Connect right and left output cables from Phono 1 to respective Phono 1 input jacks on rear of Disco Mixer. GROUND Connect Ground Cables Of both turntables to Ground Post on rear of Mixer AMP or RECEIVER Connect right and left output jacks from rear of Mixer to respective phono input jacks on AMP or Receiver. ...
Este manual também é adequado para os modelos :Instrumentos musicais - DAC X-1000 (1.45 mb)