Assessments - 3, GPA: 4
(
)
)
|
Facilidade de uso
If it is necessary to use the equipment without proper grounding facilities, suitable grounding adapters should be used. Less noise and greatly reduced shock hazard exists when the unit is operated with the proper grounded receptacles. NOTE: FOR UK ONLY As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals in your plug, proceed as follows: • The wire which is colored green and yellow must be connected to the terminal which is marked by the letter E, or by the earth symbol, or colored green or green and yellow. • The wire which is colored blue must be connected to the terminal which is marked with the letter N, or the color black. • The wire which is colored brown must be connected to the terminal which is marked with the letter L, or the color red. 7 8 RECOMMENDED SETTINGS: In In In In Out CLEAN METAL MODERATE DISTORTION In To Taste Out In Out In Out CLEAN BLUES To Taste In In Out In To Taste RHYTHM BLUES LEAD BLUES JAZZ CLEAN JAZZ RHYTHM JAZZ LEAD To Taste To Taste Out In Out TRANSCHORUS. 210 SPECIFICATIONS (ALL MEASUREMENTS @ 120 V AC, 60HZ) POWER AMPLIFIER SECTION RATED OUTPUT POWER: Power specs measured with T. Dynamics @ 100% (5% THD, 1 kHz, 120 V AC) 50 W RMS per channel, into 8 ohms FREQUENCY RESPONSE: Stereo mode into 8 ohm, power amp inputs -3 dB, +2 dB, 70 Hz to 20 kHz, @ 45 W RMS into 8 ohms HUM AND NOISE: Unweighted, 20 Hz to 22 kHz Greater than 90 dB, both channels POWER CONSUMPTION: Domestic Model: 120 V AC, 60 Hz, 2.5A, 300 W Export Model: 220 to 240 V AC, 50/60 Hz, 300 W PREAMP SECTION (The following specs are measured @ 1 kHz with the controls preset as follows:) Push Bright, off (out) Channel Select Clean (out) Low and High @ 10 Mid @ 0 Crunch Pre and Post Gain @ 10 Gain and Thrash, off (out) Lead Pre and Post Gain @ 10 Gain and Mid Boost, off (out) Normal levels are with normal volume @ 5 Minimum levels are with clean volume @ 10 PREAMP HIGH GAIN INPUT: Impedance: High-Z, 1 M ohm Nominal Input Level: -12 dBV, 250 mV RMS Minimum Input Level: -22 dBV, 79 mV RMS Maximum Input level: 0 dBV, 1 V RMS PREAMP LOW GAIN INPUT: Impedance: High-Z, 44 k ohms Nominal Input Level: -6 dBV, 500 mV RMS Minimum Input Level: -16 dBV, 158 mV RMS Maximum Input level: 6 dBV, 2 V RMS PREAMP OUTPUT: Load Impedance: 300 ohm or greater Nominal Output Level: 0 dBV, 1 V RMS POWER AMP INPUT: Impedance: High-Z, 30 k ohms Designed Input Level: 0 dBV, 1 V RMS (Switching jack provides preamp output to power amp input connection when not used.) SYSTEM HUM AND NOISE @ NOMINAL INPUT LEVEL UNWEIGHTED, 20 Hz to 22 kHz Greater than 75 dB, below rated power EQUALIZATION: Special low, mid and high passive type EQ Push Bright: +4 dBV @ 2 kHz, (Clean channel) Push Thrash: -6 dBV notch 1 kHz, (Crunch channel) Push Mid boost: +3 dBV band pass 1 kHz, (Lead channel) Push Gain: Increase gain both Lead and Crunch channels EXTERNAL FOOT SWITCH FUNCTIONS: Lead/Crunch: Selects lead or crunch channel. Bypass/Clean: Lead and Crunch channel defeat (channel switch OINO) Select/Chorus: Defeat Chorus DIMENSIONS AND WEIGHT (H x W x D): 18.5" x 23.375" x 11.375" 47cm x 10.60cm x 29cm 9 10 TransChorus . 210 BLOCK DIAGRAM TONE CLEAN HIMIDLO STEREOCHORUS DEPTHRATE EQUALIZATIONHIGHMIDLOW VOLUMECLEAN PUSHMIDBOOST HIGHGAIN AMP LEADSWITCHLOGIC SWITCH LOGICCLEAN/ULTRA INPUTS 1stGAIN STAGE LEADPOST PUSHBRIGHT PUSHBRIGHT PREGAINLEAD LEADFOOTSWITCH FOOTSWITCH PUSHCHANNEL CRUNCHPREGAIN PREGAIN PUSHTHRASH POSTCRUNCH REVERB SPEAKERPREGAINOUTPREGAINAMP INPOWERAMPLEVEL T. DYNAMICS . FOOTSWITCH PREGAINOUT PREGAIN SPEAKER DYNAMICST. . AMP IN POWERAMP IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric products, basic cautions should always be followed, including the following: 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. For example, near or in a bathtub, swimming pool, sink, wet basement, etc. 6. Clean only with a damp cloth. 7. Do not block any of the ventilation openings. Install in accordance with manufacturerOs instructions. It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air. 8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. When the provided plug does not fit into your inlet, consult an electrician for replacement of the obsolete outlet. Never break off the grounding. Write for our free booklet OShock Hazard and GroundingO. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. 10. Protect the power cord from being w...
Este manual também é adequado para os modelos :Instrumentos musicais - TransChorus 210 (2.11 mb)