Assessments - 4, GPA: 4.3
(
)
)
|
Facilidade de uso
It is 6 dB louder than Input 2. LOW GAIN INPUT (6) Provided for instruments that have extremely high outputs, which can result in overdriving (distorting) the High Gain input. If both inputs are used simultaneously, the output levels are the same (both are High Gain). GAIN (7) Controls the channcl volume. PRE EQ PATCH (8) A stereo Out/In jack provided for connecting external effects devices. A shielded “Y” cord (Peavey Part #0005299) with a Va" stereo phone plug (ring, tip and sleeve) branching into two '4" mono phone plugs is required for this connection (insert fully). The “tip” of the stereo plug routes the signal to the effects device input. The effects device output is returned through the “ring.” The “sleeve” is ground. The first click of this stereo jack can be used as a pre—EQ output without disturbing the signal flow to the remainder of the system. NOTE: If the second click of the Out/In jack is utilized without returning any signal to the system from an effects device, the remaining preamp functions will be disabled. LOW FREQUENCY EQ (9) An active tone control (shelving type, ±15 dB) that varies the low frequency range. CAUTION: Excessive low frequency boost causes greater power consumption and increases possibility of speaker damage. MID EQ (10) An active tone control (peak/notch, ±15 dB) that adjusts the mid frequency range. HIGH EQ CONTROL (11) An active tone control (shelving type, ±15 dB) that varies the high frequency range. PREAMP OUT/POWER AMP IN (12) These jacks arc provided for in-line patching of effects devices. To patch an effects unit, connect the Preamp Output to the Input of the device. Next, connect the output of the device to the Power Amp Input (high-quality shielded cables must be used for these connections). The Preamp Output can also be used to route the amplified signal to a mixing console, tape recorder, etc. Connect the Preamp Output, using a shielded cable, to an input of the tape recorder, mixer, etc. This patch does not affect the operation of the amplifier. NOTE: The preamp output level is approximately 1 volt RMS and is of relatively low impedance (600 ohms). Any effects device used in this effects loop must be capable of receiving 1 volt input and providing 1 volt output in order to properly drive the power amp. The Power Amp Input has an internal switch which disconnects the internal preamp. MASTER REVERB (13) Determines the overall effects level supplied to the internal reverb unit. POWER LED (14) Illuminates when AC power is being supplied to the amp. GROUND SWITCH (15) Three position rocker-type switch which, in most applications, should be operated in its center or zero position. There may be some situations when audible hum and/or noise will come from the loudspeaker. If this situation arises, position the ground switch to either positive or negative ( + or -) or until the noise is minimized. NOTE: Should the noise problem continue, consult your Authorized Peavey Dealer, the Peavey Factory, or a qualified service technician. THE GROUND SWITCH IS NOT FUNCTIONAL ON 220/240 VOLT MODELS. POWER SWITCH (16) Depress the switch to the “On” position. The red pilot light (LED) will illuminate indicating power is being supplied to the unit. 17 18 t?0 VAC 60 Hi tso WAITS BUfcT UNDER US PATENT NO * J'8053 + WARNING TOMEVtN' !l< FIS* AAOS-CCK iWA»V X> MCI cXPOSi TK-S APPl'ANCf TO RAIN <>» — wxsrmil 00 W! WVCvEFBOMCASl NOlrttH StiverAflli »AMtSriSCF RE=fcRSir
Instrumentos musicais - KB 60 (3.8 mb)