Assessments - 2, GPA: 5 ( )

Fabricante : VOX Amplification USA Arquivo Tamanho: 989.82 kb Arquivo Nome : Língua de Ensino:

If you want to disconnect the internal speakers simply unplug the jack. Be sure to set the IMPEDANCE SELECT switch accordingly. (See “IMPEDANCE SELECT Switch”) WARNING! To ensure that your system works correctly, you must observe the following points. a) Don’t use an extension cabinet whose impedance is anything other than 16 ohms. b) Don’t connect a speaker whose rated input capacity is less than 30 watts (for AC30HW) or 15 watts (AC15HW). The speaker may be destroyed if you ignore this caution—not recommended! c) You must use a speaker cable to connect an external speaker. Don’t use a shielded cable like the one you use to connect a guitar to an amp. d) You must turn off the power before connecting the speaker cable. Connecting the cable while the power is turned on may damage your amp. NOTE! It is recommended that all audio cables (with the exception of the speaker lead), used to connect to the AC30HW/AC15HW are of a high quality, screened type. These should not exceed 10 metres in length. Always use a non-screened VOX approved speaker lead with the AC30HW/AC15HW Amplifier and extension cabinets. 2. IMPEDANCE SELECT switch 16 OHMS: Combos allow for the following configurations: a) Set it to this if you use the internal speakers only. b) Set it to this if you connect an external 16 Ohm speaker cabinet through the External jack (internal speakers disconnected). 8 OHMS: Combos allow for the following configurations: a) Set it to this if you connect an extension cabinet. You’ll be running the internal and external speakers in parallel. The impedance of the extension cabinet must be 16 Ohms. b) Set it to this if you connect an external 8 ohm speaker cabinet through the External jack (internal speakers disconnected). 3. FOOT SWITCH jack This is where you connect the included Foot Switch (VFS1) to switch between HOT and COOL modes on the TOP BOOST Channel (HOT Mode must be engaged on the control panel for the Foot Switch to operate) 4. MAINS INPUT connector This is where the supplied, detachable Mains (power) cord is connected. The specific mains input voltage rating that your amplifier needs to run at is located on the rear panel of your amplifier. Before making any connections or powering up the amplifier, make sure the correct voltage is set. If you have any doubt, refer to your local VOX dealer. 8 Specification AC30HW2X: • Dimensions (W x D x H) • Weight • Output Power • Tube Complement • Speakers • Inputs • Outputs • Included items AC30HW2: • Dimensions (W x D x H) • Weight • Output Power • Tube Complement • Speakers • Inputs • Outputs • Included items AC30HWH: • Dimensions (W x D x H) • Weight • Output Power • Tube Complement • Inputs • Outputs • Included items AC15HW1X: • Dimensions (W x D x H) • Weight • Output Power • Tube Complement • Speakers • Inputs • Outputs • Included items AC15HW1: •Dimensions (W x D x H) • Weight • Output Power • Tube Complement • Speakers • Inputs • Outputs • Included items V212HWX: • Dimensions (W x D x H) • Weight...

Baixe o seu

Para fazer o download, introduza 2 dígitos :