Assessments - 4, GPA: 4.3 ( )

Fabricante : AmpliVox Arquivo Tamanho: 4.67 mb Arquivo Nome : Língua de Ensino:

UHF-216 DUAL CHANNEL RECEIVER OPERATION: 1. Remove all packing materials. Save the box and packing materials to transport the unit and in case the unit ever requires service. 2. Plug the AC/DC adaptor into the rear of the receiver (6) and an appropriate AC Outlet. Push the Power On (2) button to turn the unit on. The power indicator will be illuminated. 3. Extend the two antennas fully vertical and point them towards the direction the performer(s) will be speaking from. 4. Insert the 1/4” cable into the jack labeled AUDIO OUT (5) on the rear of the receiver and connect the other end of the cable to your amp, effects or mixer jack. 5. Set the channel selector pins (7) on both the transmitter and receiver to the desired frequency as indicated on the included Frequency Chart. 6. Adjust the volume using the level control on the front panel. Note: Effective range between the transmitter and receiver is up to 250 feet. HAND HELD TRANSMITTER OPERATION 1. Slide the battery cavity (9) to open. Insert two (2) AA batteries into the battery cavity (9) according to the polarity indication marked on the battery housing. 2. Set the channel selector pins (7) on both the transmitter and receiver to the desired frequency as indicated on the included Frequency Chart. 3. Close the battery cavity (9). 4. Push the power switch (8) to the ON position. The BATT indicator (10) should flash once briefly as you turn on the mic indicating that the mic has sufficient power. If the BATT stays on, it indicates that the battery has insufficient power and should be changed. If the BATT does not light at all and the mic does not work, it indicates the battery is dead and you should change the battery. The microphone can be muted by setting the switch (8) to the mute position. If the microphone is not going to be used for any length of time, push the power switch (8) to OFF and remove the battery. Do not switch the mic on and off rapidly, because you wont get a true indication from the BATT indicator. HEADSET/LAVALIER COMBO AND TRANSMITTER OPERATION 1. Slide the battery cavity (9) to open. Insert two 2 AA batter UHF-216 DUAL CHANNEL WIRELESS SYSTEM Transmitter Operation 12 13 System Control Control de sistema • Utilisation • Systemeinstellungen System Control Control de sistema • Utilisation • Systemeinstellungen ies into the battery cavity (9) according to the polarity indication marked on the battery housing. Close the battery cavity. 2. Set the channel selector pins (7) on both the transmitter and receiver to the desired frequency as indicated on the included Frequency Chart. 3. Push the power switch (11) to the ON position. The BATT indicator should flash once briefly as you turn on the mic indicating that the mic has sufficient power. If the BATT stays on, it indicates that the battery has insufficient power and should be changed. If the BATT does not light at all and the mic does not work, it indicates the battery is dead and you should change the battery. If the microphone ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :