Assessments - 5, GPA: 3.4
(
)
)
|
Facilidade de uso
Finally, insertthescrew into the pedal guide and tighten it. At this time, be careful not to catch the battery strap in the cover or coil spring. SPECIFICATIONS POWER CURRENT DRAW CONTROLS OTHERS JACKS SYSTEM DELAY TIME HOLD TIME FREQUENCY RESPONSE RESIDUAL NOISE INPUT IMPEDANCE OUTPUT LOAD IMPEDANCE DIMENSIONS WEIGHT 9V DC Dry Battery, AC ADAPTOR (PSA-1 20, 220 or 240) 45mA to 65mA (9V DC) EFFECT LEVEL, FEEDBACK, DELAY TIME, MODE SELECTOR SWITCH NORMAL/EFFECT CHANGEOVER (HOLD ON/OFF) FOOT SWITCH INPUT, DIRECT OUTPUT, MAIN OUTPUT AC ADAPTOR (PSA-120, 220 or 240) ANALOG LOGALITHMIC COMPRESSION AND 12 BITS QUANTIZING SYSTEM 12.5m.s(MIN) to 800ms(MAX) S(SHORT) 50ms (12.5ms to 50ms) M(MIDDLE) 200ms (50ms to 200ms) L(LONG) 800ms (200ms to 800ms) 200ms(MIN) to 800ms(MAX) in Hold mode DELAY SOUND:40Hz to 7kHz/-3 dB DIRECT SOUND: 10Hz to 60kHz/ dB — 95dBm( IH F-A) IMil 10ki2 or more 70(W)x55(H)x125(D)mm/ 2-3/4(W)x2-3/16(H )x5(D) in. 450g/1 lb. *The specifications are subject to change without notice. 2603068700 '90-4-E3-13Y CONNECTING Bescheinigung des Herstellers /Importeurs i TO AC Adaptor Jack I AC ADAPTOR BOSS PSA-series 30 0 • Connect only to this jack to obtain monaural sound. • Mixed sound of the delay and direct in Normal mode. • Only the delay sound in Ste-_ reo mode. AMPLIFIER In case requiring only the delay sound (for connecting to Echo Send/Return of a mixer), use only the Direct Output Jack. DD-3 Power is switched on while a plug is put into Input Jack. Only the direct sound Unplug this unit when it is not to be used. Be sure to take' off connecting plug from Input jack?) AMPLIFIER Hiermit wird bescheinigt, daß der/die/das DIGITAL DELAY DD-3 {Gerät, Typ. Bezeichnung) in Übereinstimmung mit den Bestimmungen der Amtsbl. Vfg 1046 / 1984 {Amtsblattverfügung) funk-entstört ist. Der Deutschen Bundespost wurde das Inverkehrbringen dieses Gerätes angezeigt und die Berechtigung zur Überprüfung der Serie auf Einhaltung der Bestimmungen eingeräumt. Roland Corporation Osaka / Japan Name des Herstellers/Importeurs id the Class B Jt in the Radio lan Department DESCRIPTION CHECK INDICATOR The Check Indicator enables you to confirm if the Effect is ON or OFF, and as well to check the battery. If the Check Indicator lights up by pressing the Pedal Switch down, Delay Effect is on, and if goesout, Delay Effect isOFF(Normal). *Hold Effect works as long as the pedal is held down. *The battery should be replaced, when the indicator lights but only dimly or does not light UPa,a"- EFFECT LEVEL This knob controls the output level of the delay sound. Turing this knob clockwise increases the level of the delay sound. With this knob turned fully counterclockwise, the output level of the delay sound is equivalent to that of the direct sound. Also when this knob is turned fully counterclockwise in Normal mode, only the direct sound Is obtained, while no sound is heard from the Main Output in Stereo mode. MAIN OUTPUT JACK Monaural signal (the mixed signal of the direct and delay sounds) is output from this jack. (If the plug is not connected to the Direct Output Jack■) FEEDBACK LEVEL This knob decides how many times the delay sound is to be repeated. Turning this knob clockwise increases the number of repetition of delay sound, and turning this knob fully counterclockwise produces single delay sound. OUTPUT input <- DIRtCTOUT^ Digital Delay DELAY TIME This knob allows to finely adjust the delay time set with the Mode Selector Switch by from "X 0.25" to "X1" continueously. Turning this knob clockwise increases the delay time, and counterclockwise decreases it. INPUT JACK This jack should be connected to an electric guitar or other musical instrument. *The unit is powered on by plugging to the InputJackand is powered OFF by unplugging. *By muting circuit system no Effect works for about 5 seconds after the unit is powered on. DIRECT OUTPUT JACK When a plug is connected to this jack, direct sound is output from this jack, and delay sound isoutputfrom the Main Output Jack. -•AC ADAPTOR JACK The AC-adaptor (BOSS PSA-120, 220 or 240) should be connected to this jack. *BOSS ACA-series must not be connected, use specifically PSA:serles. -•MODE SELECTOR SWITCH The Mode Selector Switch has 4 modes, S, M, L, and Hold. The delay time changes from 12.5ms to 800ms continueously by using this selector and the Delay Time knob. In Hold mode, the Delay Time knob controls the repetition time of the hold sound from 200ms to 800ms. The Pedal Switch works as long as the pedal is held down. -•THUMBSCREW When the battery needs replacing, loosen this screw to open the pedal and replace the battery with a new one. *The screw should not be pulled out, but if needs removing for some reason, do not lose it. -•PEDAL SWITCH The Pedal Switch works as Delay Effect ON/OFF or Hold ON/OFF switch. *Due to FET-switching system, audible click noise problem is solved, thus the DD-3 is most sui...