Assessments - 3, GPA: 3.3 ( )

Fabricante : Roland Arquivo Tamanho: 604.86 kb Arquivo Nome : Língua de Ensino:

5). These sections provide important information concerning the proper operation of the product. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new product, Owner’s manual should be read in its entirety. The manual should be saved and kept on hand as a convenient reference. (P.7)££<£^#<£3 Thank you, and congratulations on your choice of the Roland V-Stand KS-STV7. * V-Stand™ is a trademark of Ultimate Support Systems, Inc. Setting Up the Stand 1. Face stand on “playing” side. 2. Fully open tier clamp. — SECOND TIER KS-STV7 * V-Stand Ultimate Support Systems, Inc. ©MiT^o 1. >i#T3£f^ftfT\X£>K(KS-V7)№M'£Tc 2. ^7>y(Sfe^)ê^otf^î?^tîto Open Clamp (R) -ÀS 3. Wrap clamp, with hinge on playing side, around stand strut on notch number 1 or 2depending on desired tier height. The hinges are inscribed with markings; set the hinges so that the markings face inward. L refers to the left side and R to the right when facing the stand (KS-V7). Notch - X^>R(KS-V7)M^T 4. There is a locating nub inside the clamp that fits into strut notch. Tighten outside knob. * There is a left and right side clamp. Repeat for other side. Take care not to reverse the left and right sides. 4. * ^>Æt(L) É(R)a^OfOÈUiîot9-Æ® Copyright © 2005 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. X © 2005 P-7>K^^è*± 0 4 2 3 1 1 5 6 - 0 1 04231156 1UL 5. First loosen the knobs on the inner side of the struts. Select a width position (either straight up or angled in). Slide tier from the back of the stand into the clamp slot opening, matching tier grooves with slot groove. 5. 7. Repeat for other side. You can change the tier width side to side by aligning the notch positions. 8. To adjust tier arm angle, loosen knob, select angle position (15° increments) and tighten. Repeat for other side. * Take care not to loosen the angle adjustment knob too much when loosening the knob. * Differences in the angle of the left and right arms will make the keyboard unstable; be sure to set the arms to the same angle. * Check to see that the stand is safe to use, confirming that the arms have the stoppers in front and in a lowered position and making sure that the stand will not tip over. 7. TfSto 8. 7-A©Âl^ÜUÎÎoÂliI/7^ife éiU^lCiSLSÎo Üo If using the KS-V7 with the KS-STV7 attached, do not use the stand with a keyboard only resting on the KS-STV7. Be sure to place a keyboard on the KS-V7 as well. Load capacity of tier is 75 lbs. (34 kg) Load capacity of stand is 250 lbs. total (113.4 kg) KS-V7 (ü KS-STV7 KS-STV7 t’^C+-^-h^©tttttlrffflLÖÜ?h*-x^7-(KS-STV7) ©MMtt34kg(75lbs.) T'^o KS-V7©MMttê§+ 113.4 kg(250 lbs.) T*^0 2 1 MEMO MEMO 3 4 04231156-01 USING THE UNIT SAFELY Information When you need repair service, call your nearest Roland Service Center or authorized Roland distributor in your country as shown below. INSTRUCTIONS FOR THE PREVENTION OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS About A'WARNING and A CAUTION Notices About the Symbols A WARNING Used for instructions intended to alert the user to the risk of death or severe injury should the unit be used improperly. A CAUTION Used for instructions intended to alert the user to the risk of injury or material damage should the unit be used improperly. * Material damage refers to damage or other adverse effects caused with respect to the home and all its furnishings, as well to domestic animals or pets. A The A symbol alerts the user to important instructions or warnings.The specific meaning of the symbol is determined by the design contained within the triangle. In the case of the symbol at left, it is used for general cautions, warnings, or alerts to danger. The symbol alerts the user to items that must never be carried out (are forbidden). The specific thing that must not be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the unit must never be disassembled. The • symbol alerts the user to things that must be carried out. The specific thing that must be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the powercord plug must be unplugged from the outlet. ALWAYS OBSERVE THE FOLLOWING ^WARNING Before using this product, make sure to read the instructions below, and the Owner's Manual. A 0 Do not open or perform any internal modifications on the product. (The only exception would be where this manual provides specific instructions which should be followed in order to put in place user-installable options; see pp. 1-2.) Do not attempt to repair the product, or replace parts within it (except when this manual provides specific instructions directing you to do so). Refer all servicing to your retailer, the nearest Roland Servic...

Baixe o seu

Para fazer o download, introduza 2 dígitos :