Assessments - 4, GPA: 4.3
(
)
)
|
Facilidade de uso
No part of this publication may be reproduced in I any form without the written permission of ROLAND CORPORATION. SA-1000 Connection Guide When connecting the SA-1000 with other equipment, be sure to read the owner's manuals for the SA-1000 and each device being connected. Turn Off the Power to All Devices Turn down the VOLUME knobs on all devices being connected to lower the volume completely, then turn off their power. SA-1000's Control Panel MIC nc: 1 REVERB Ü1 0 m Also lower the VOLUME on the keyboard you're connecting T—to the minimum level, then turn off the power. Be sure to refer to the owner's manual for the keyboard you're connecting before carrying out this procedure. Keyboard to be connected 2 Connect the Keyboard Use a connecting cable (optional) with 1/4" phone plugs to connect the keyboard's output jacks to the SA-1000's KEYBOARD IN jacks. To KEYBOARD IN jacks on rear panel Commercially available connecting cable * The name and shape of the jacks can vary depending on the keyboard. For details, refer to the owner's manual that came with the keyboard you're connecting Connect the Subwoofer (SA-1000W) -> Use the dedicated cable included with the amp to connect the SA-1000 and SA-1000W. 3 Turn on the Power Turn on the power to the devices in the sequence described below. Switch on the power according to the instructions in the owner's manuals for the SA-1000 and each device being connected. First, turn on the power | to the keyboard. Next, turn on the power to the SA-1000. a Lastly, turn on the power to the SA-100( connected through Stereo Link. When Connecting a Second SA-1000 with Stereo Link To STEREO LINK OUT TO To STEREO LINK IN SIDE R jack on rear panel jack on rear panel Adjust the Volume First, raise the keyboard's volume, then increase the SA-1000's INPUT VOLUME settings. - Raise the keyboard's volume to 60-70% of the maximum level. However, if speakers are connected, set the volume to a listenable level. *T Roland Ü Zf 1 1 n \ If using Stereo Link, the settings for the MASTER section of both SA-1000s need to be set so they match. SD001051 2DH SD00...