Assessments - 1, GPA: 5
(
)
)
|
Facilidade de uso
Place the TU-8 close to the instrument (or vice versa). 3.Select the required Tuning mode (Guitar, Bass or Open Tuning (D, E, G or A)) using the Tuning Mode switch. 4.Select the string (note name) you wish to tune. Press the NOTE button repeatedly until the appropriate string (note name) indicator lights. 5.Play single notes on the instrument. The input note and the amount by which the pitch differs from the selected String Name are shown by the Meter and Tuning Guide Indicators. 6.Tune the instrument. After getting both the " b " and " # "Tuning Guide Indicators to light, tune the instrument so the Meter's needle is at "0." Repeat the procedure for each string. Making the Connections OI3DS5 ти-e t. MIC ¡да qj==^ j AC Adaptor(Optional) Amplifier- Acoustic Guitar .41 Electric Guitar 1 Ф -s Electric Bass Flat/Double Flat Tuning Changing the Battery Flat tuning is a semi-tone below standard tuning. The LED display will still show the notes as if it were standard tuning, but the absolute pitch will be a half-step lower. This makes it easier to tune and play in flat keys. Double flat tuning is the same thing only a whole tone lower than absolute pitch. * When you select Open Tuning mode> you cannot select Flat (or Double Flat) Tuning. 1 .Each press of the Flat button selects one of three conditions: standard tuning, flat tuning or double flat tuning. This condition can be checked by the flashing of the Flat/Double Flat Indicator. Regular Tuning Flat Tuning Double Flat Tuning ~ -O- * When you select Flat (or Double Flat) tuning, you should first tune each string using the MANUAL mode. * Even if you select Flat (or Double Flat) tuning, the TU-8 will return to standard tuning when you power up again. 1 .Press down and slide off the lid of the battery compartment (located on the bottom of the unit). 2.Remove the old battery from the compartment and disconnect the snap cord. 3.Connect the snap cord to the new battery. 4.Place the new battery inside the compartment and slide the lid back into place. Changing the Reference Pitch ■ Specifications Reference Pitch refers to the frequency of note A4 (on a piano, the key at the center of the keyboard) on the instrument that will provide the predominate tonal focus of a performance (such as the piano). You should tune all instruments so they are in tune with this Reference Pitch. At power up, the reference pitch of the TU-8 is set to 440 Hz (for note A4). If you intend to change the reference pitch, perform the following steps. I.Set the Power/Mode switch to "AUTO" or "MANUAL". 2.Check the current reference pitch. Press the PITCH button once and the indicator which shows the current pitch will blink for a few seconds. 3.Adjust the reference pitch. While the indicator which shows the current pitch is blinking, press the PITCH button once again. Each press of the button raises the pitch by 1 Hz. Press the button enough times to obtain the desired settingfor the reference pitch. This can be confirmed by watching for the desired reference pitch indicator to begin blinking. The reference pitch can be set anywhere between 438 to 445 Hz (in 1 Hz increment) for note A4. If you make no further changes in the reference pitch for a few seconds, the indicator will go out, and the unit reverts to the tuning mode. * The reference pitch will return to 440 Hz the next time the unit is turned on. Battery Check When the battery is nearly exhausted, the two Tuning Guide Indicators (" b " and " £ ") will begin blinking. After a few seconds, the indicators stop blinking and you can tune again. At this point, replace the battery as soon as possible. Furthermore, when powering up or while working, if the battery has been exhausted, the two Tuning Guide Indicators will blink and you cannot tune. Replace the battery immediately. TU-8 Guitar & Bass Auto Tuner Reference Pitch :A4 = 438 Hz to 445 Hz (1 Hz steps) Tuning Range :A0 (27.5 Hz) to C8 (4186.0 Hz) Tuning Accuracy :+/- 1 cent Input impedance :1 MO Controls :Power/Mode Selection Switch, PITCH Button, NOTE Button, Tuning Mode Switch, Flat Button Indicators :String Name Indicator, Flat/Double Flat Indicator, Tuning Guide Indicators Connectors :lnput Jack, Output Jack, AC Adaptor Jack Power Supply :DC 9V :Dry Battery (9V type), AC Adaptor PSA-Series Current Draw :20 mA (typical) * Expected battery life under continued use. (This figure will vary depending on the actual conditions of use.) Carbon :approx. 10 hours Dimensions :149 (W) x 54 (D) x 32 (H) mm 5-7/8 (W) x 2-1/8 (D) x 1 -1/4 (H) inches Weight ;1 75g / 6.2 oz (including battery) Accessories ;Dry Battery S-006P/ 6F22 (9 V), Owner's Manual Option :PSA-Series (AC Adaptor) Copyright ©1993 BOSS CORPORATION * The specifications and/or appearance of this product are subject to change without prior notice. * All right reserved. No part of this publication maybe reproduced in any from without the written permission of BOSS CORPORATION....