Assessments - 3, GPA: 4.7 ( )

Fabricante : Seagate Arquivo Tamanho: 116.08 kb Arquivo Nome : Língua de Ensino:

Preparing the drive using DiscWizard Installing a single drive If you are installing a single drive, we recommend using DiscWizard to automatically partition and format your drive. DiscWizard software is available at and is free. During the download, the Diskette Creator creates a portable bootable diskette. To run DiscWizard: 1. Insert your bootable DiscWizard diskette and follow the instructions. DiscWizard will guide you through the installation process. 2. Boot your computer from the Windows operating system CD-ROM or from your system startup diskette with the Windows CD loaded. At the prompt, type setup. Follow the instructions provided on your screen. Installing a slave drive If you are installing a second drive, or slave, to your system, use the DiscWiz ard software available at If you do not want to install your drive using either DiscWizard or Disk Manager, see “Standard Microsoft Installation” below to partition and format your drive. Standard Microsoft installation Caution. Partitioning or formatting a drive erases all data on the drive. Seagate assumes no liability if you erase your data. 1. Insert a bootable Windows startup diskette and restart your computer. This is provided with your Microsoft Windows operating system software. 2. Run fdisk and create a primary DOS partition. 3. Mark the partition as active to make the partition bootable. Drive formatting Caution. Use the correct drive letters to prevent formatting a drive that already contains data. 1. At the A: prompt, type format x: (where x is the letter of your first new partition) and then press the Enter key. Repeat the format process for all new partitions. 2. Proceed to “Loading the operating system” below. Loading the operating system Note. The operating system needs to be installed on the master drive only. It is not required when adding a second drive. 1. Boot your computer from your Windows operating system CD-ROM or from your system startup diskette with the Windows CD loaded in the CD drive. 2. At the prompt, type setup and continue with the Windows setup as instructed on your screen. Troubleshooting If your drive is not working properly, these troubleshooting tips may help solve the problem. 1. Does the drive spin up? A spinning drive produces a faint whine and clicking noise that begins when power is applied. If your drive does not spin, check that the power connector and interface cable are securely attached and the jumpers are installed correctly. 2. Does the computer recognize the drive? Verify that the drive is enabled in the system CMOS or setup program. If not, select the autodetect option and enable it. If your drive has a problem, it may not be recognized by the system. 3. Does FDISK detect the drive? Run the FDISK program located on your Windows startup diskette. Type fdisk/status to verify that your hard drive is present and recognized by the system. 4. Does Scandisk find the drive defect-free? Scandisk is a utility locate...

Baixe o seu

Para fazer o download, introduza 2 dígitos :