Assessments - 1, GPA: 4
(
)
)
|
Fotos e especificações Sony NW-MS9 |
Facilidade de uso
low battery Please charge the battery If “LOW BATT” is displayed in the display, you need to recharge the battery. Basic Operations Transferring songs from the computer to the “Memory Stick” (Check-Out) In order to check-out digital audio files from your computer, first you must install the supplied OpenMG Jukebox software and then import digital audio files to OpenMG Jukebox. For details, refer to the OpenMG Jukebox operating instructions. 1 Connect Network Walkman to your computer. 1 Insert “MagicGate Memory Stick.” Access lamp “MagicGate Memory Stick“ Memory Stick slot Notes • When connecting Network Walkman to your computer, make sure the erasure prevention switch of the “Memory Stick” (page 23) is OFF . • Insert the “Memory Stick” into the slot until it clicks into place. 2 Connect Network Walkman to your computer. Connect the narrow connector of the supplied dedicated USB cable into the dedicated USB jack on Network Walkman, then the wide connector to the USB jack of your computer. “CONNECT” appears in the display. USB cable (supplied) to to Notes • The access lamp blinks while transferring data files. • Do not remove the USB cable or the “Memory Stick” while blinking of the access lamp blinks. It may cause the data to become corrupted. Notes • Do not connect more than two USB devices to your computer. Normal operation will not be guaranteed. • Use of this player with a USB hub or a USB extension cable is not guaranteed. • A malfunction may occur depending on the USB devices connected at any one time. • When connecting Network Walkman to your computer for the first time, check if the OpenMG Jukebox icon appears on the tasktray. If the icon appears, remove it from the tasktray. And then connect Network Walkman to your computer with the supplied dedicated USB cable and start the OpenMG Jukebox software. (This procedure is only necessary the first time you connect to your computer.) continued Basic Operations Transferring songs from the computer to “Memory Stick” (Check-Out) (continued) 2 Transfer the music file to the “Memory Stick” (Check-out). For details on how to operate, refer to the OpenMG Jukebox operating instructions. When the cover of the USB connector is released. After releasing the cover, to reconnect, follow the steps below. 1 Insert the stud of the cover into the hole of 2 Rotate the cover in the direction of the the Network Walkman as shown. arrow and insert the other stud into the opposite hole as shown. Connect this side first. Sets the cover beyond the center projection of Network Walkman. b Tip To transfer the song back to the computer (check-in), refer to the OpenMG Jukebox software instruction manual or the online help. Listening to music with Network Walkman Please charge the battery before use (see page 8). Note When using Network Walkman, be sure to disconnect it from the computer. 1 Insert a recorded “MagicGate Memory Stick” into Network Walkman. When the “Memory Stick” is inserted into the slot, “ACCESS” appears. All the music files and total playing hours appear. “MagicGate Memory Stick“ Memory Stick slot Basic Operations 2 Connect the headphones/earphones. to i jack 3 Start playback. 1Press the Seesaw key. 2 Press the VOLUME +/– button up or down to adjust the volume. HOLD switch (Release this switch before playback.) Playback stops automatically when the music reaches the end (only when REPEAT OFF is selected). If playback does not start The HOLD switch may be switched down. Please release it up (page 16). To stop playback Press the Seesaw key. To adjust the volume The volume can be set in PRESET and MANUAL mode (page 16). Tip If you do not operate the player for 10 seconds while in stop mode, the display automatically turns off. When scrolling song titles, etc., the display turns off after scrolling is finished. continued 11 Listening to music with Network Walkman (continued) On other operations On the display Seesaw key Press (PUSH) Press (.) Press (>) To Operation of the Seesaw key Go to the beginning Press (>) once. of the next track Go to the beginning Press (>) repeatedly. of the succeeding tracks 1) Go to the beginning Press (.) once. of the actual track Go to previous Press (.) repeatedly. tracks 1) Go forward 2) During playback, press (>) and hold. Go backward 2) During playback, press (.) and hold. 1) Pressing and holding (>) of the Seesaw key during stop mode allows you to go to the beginning of the next and succeeding tracks continuously. Also, pressing and holding (.) of the Seesaw key during the stop mode allows you to go to the beginning of the previous and further tracks continuously. 2) Passing five seconds after starting fast forwarding or fast rewinding operations, its speed increases. To take out the “Memory Stick” Open the cover of the “Memory Stick” slot, then slightly push and release the “Memory Stick.” 1 23 001 02:01 45 1Text/graphic information display (page 15) Display truck number, song title, current date and time (page 18) and menu. In the grap...