Assessments - 2, GPA: 4
(
)
)
|
Facilidade de uso
Use a punch to create a pilot hole or drill a pilot hole. However, when drilling pilot holes be extremely careful. Do not drill holes a!l the wag through the countertop. Panel Support Note: Measurements are to Center of Holes Installation Instructions STEP 4 FASTEN PANEL SUPPORT BRACKET TO UNDERSIDE OF COUNTERTOP AND TOEKICK PANEL TO FLOOR Fasten the panel support bracket to the underside of the countertop using two #8 x 3/4" wood screws and two 3/16" flat washers. Mount Panel -Support Bracket I to Underside of . ? Mount Toe _d_, Kick Panel--_]\ to Floor Figure D Fasten the toekick panel to the floor using two #10 x 1" wood screws and two 3/16" flat washers. If the floor is ceramic tile or similar material that will not accept screws, use two lag bolts of appropriate size and length along with 2 flat washers to fasten the toekick panel to the floor. STEP S LOOSELY INSTALL SIDE PANEL Mount the side panel to the toekick panel and panel support bracket using four 1/4"x 3/8" machine screws, 4 lock washers and four 1/4" nuts. Do not tighten the fasteners at this time. Figure E STEP 6 POSITION PANEL AGAINST BACK OF CABINET Skip this step and go to Step 10 if the back of the dishwasher enclosure is not a wall or if gou choose not to fasten the side panel to the back of the dishwasher enclosure. Gentlg push side panel against the rear wall of the dishwasher enclosure. Mark the location of the screw cutouts in the panel on the back wall of the enclosure. Figure F STEP 7 DETERMINE WALL COMPOSITION If wall is solid or there is a stud behind the panel, attach the panel to the wall using two #10 x 1" wood screws and two 3/16" flat washers. Install the screws Iooselg -do not tighten. Skip to Step 10 If wall is hollow, for example, drgwall without a stud, it will be necessarg to use toggle bolts to attach the side panel to the wall. STEP 8 INSTALL TOGGLE BOLTS Remove side panel from toekick and support bracket. Drill a 1/2" hole at each of the positions marked in Step .6.Place a washer on the 3" machine screw. Screw the toggle onto the bolt a few turns. Insert toggle into the top hole in the wall. Repeat with a second toggle bolt in the bottom hole. Do not tighten toggle bolts at this time. J Wall--. _ Washer Toggle Bolt J installation instructions STEP 9 ATTACH SIDE PANEL TO SUPPORT BRACKET AND TOGGLE BOLTS Place the side panel against the panel support bracket and insert two 1/4" machine screws through the side panel and support bracket while aligning the side panel with the toggle bolts. Install the lock washers and 1/4" nuts on the machine screws but do not tighten. Install the remaining two 1/4" machine screws through the side panel and toekick panel. Install the lock washers and 1/4" nuts on the machine screws, but do not tighten. STEP iO TIGHTEN THE FASTENERS Tighten the fasteners in this order: 1. Toggle bolts or wood screws on back of panel (if present) 2. Machine screws on top of panel 3. Machine screws on bottom of panel. Tighten Figure H imc]ginc]tion (It work SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE GE Consumer & Industrial General Electric Compang Pub. No. 31-30204 Louisville, Kentuckg 40225 Dwg. No. 206C1559P144 ge.com ND 05J-1434 (9/05) ...
Este manual também é adequado para os modelos :Placa - GPS5CC (265.68 kb)