Assessments - , GPA: ( )

Instruções de Operação Bosch, Modelo HE2416U

Fabricante : Bosch
Arquivo Tamanho: 4.69 mb
Arquivo Nome :

Língua de Ensino:

O documento está colocado, por favor, espere

Baixe o seu Fechar

O documento está colocado, por favor, espere

Baixe o seu Fechar

Use undiluted white vinegar, rinse and dry. Recondition with Cooktop Cleaning Creme. Surface Scratches • Apply Cleaning Creme before using to remove sand like grains and grit such as salt and seasoning. • Can be reduced by using pans with bases that are smooth, clean, and dry before use. Use Cooktop Cleaning Creme daily on the cooktop. Care and Cleaning English • 25 Self Help Care and Cleaning Use - The Cooktop Getting Started Preparing the Oven for Self-clean 1. Remove all utensils and bakeware. 2. Remove oven racks. If oven racks are left in the oven during the self-clean cycle, they will permanently lose the shiny finish and will no longer glide smoothly on the rack giudes. See Oven Cleaning Chart for proper care. 3. Wipe up any soft soil spills and grease with paper towels. Excess grease will cause flames and smoke inside the oven during self-cleaning. 4. Review illustration below. Some areas of the oven must be cleaned by hand before the cycle begins. Use a soapy sponge or plastic scrubber or a detergent-filled S.O.S.® pad. Hand-clean the oven door edge, oven front frame and up to 1-1/2 inches inside the frame with detergent and hot water. Do not clean or rub the gasket on the oven. The gasket is designed to hold in heat during the self-clean cycle. Rinse all areas thoroughly then dry. 5. Be sure oven light is turned off and the light bulbs and lens covers are in place. Do not operate oven without light bulb and cover in place. Self-cleaning the Oven Caution: Do not use Commercial Oven Cleaners on the self-clean oven or any oven part. They can damage the finish or the part. DO NOT hand clean gasket DO hand clean frame area outside gasket DO hand clean door area outside gasket DO hand clean 1-1/2" from rack guides to front of oven cavity. The Siemens Range features a self-cleaning function that eliminates the manual labor involved with cleaning your oven. During self-cleaning, the oven uses a very high temperature to burn away food soil and grease. • It is common to see smoke and/or an occasional flame-up during the Self-Clean cycle, depending on the content and amount of soil remaining in the oven. If a flame persists, turn off the oven and allow it to cool before opening the door to wipe up the excessive food soil. • In a normal Self-Clean Mode, the door does not lock at the beginning of the cycle; However, it does lock prior to reaching the high self-clean temperatures. The door lock symbol will appear in the display at this point. The door does not lock at the start of the cylce. • The oven light does not operate during this mode. • During Self-Clean, the kitchen should be well ventilated to help eliminate odors associated with Self-Clean. Odors will lessen with use. • Four hours is the preset length of cleaning. The range can also be set to clean for 3 or 5 hours. • The mode automatically stops at the end of the clean hours. • When the oven heat returns to a safe temperature after cleaning, the automatic door lock will release and the door can be opened. Care and Cleaning - The Oven WARNING A flexible door gasket is necessary for a good seal. Do not clean, rub, damage or move the gasket. Care and Cleaning - The Oven Setting the Self-Clean Mode 1. Touch COOKING MODE. 2. Turn knob until SELF CLEAN mode appears. Press START. 3. The default cleaning time is 4 hours. To change cleaning time, turn knob to change number of hours (See Figure 1). Otherwise, continue to step 4. 4. Touch START. SELF-CLEAN flashes. Press START. 5. REMOVE RACKS appears in the display as a reminder to remove oven racks (See Figure 2). 6. Touch START again to begin the self-clean. Note: In a normal Self-clean mode, the door does not lock at the beginning of the cycle; However, it does lock prior to reaching the high self-clean temperatures. The door lock symbol will appear in the display at this point. Delaying the Start of the Self-Clean Note: The time of day must be correctly set for this option to work properly. See section “Setting the Clock” in “Setting Up Your Range”, Page 5. 1. Touch COOKING MODE. 2. Turn knob until SELF CLEAN mode appears. Press START. 3. The default cleaning time is 4 hours. To change cleaning time, turn knob to change number of hours. Otherwise, continue to step 4. 4. Touch START. 5. Turn knob until DELAYED CLEAN mode appears (See Figure 3). Press START. 6. SELF CLEAN END appears in the display. 7. Turn knob to enter the time of day you want the self- clean to end: Set hours, touch time, set minutes (See Figure 4). 8. Touch START. The display will remind you to remove oven racks (See Figure 2). 9. Touch START. The display shows DELAYED CLEAN. The self-clean will automatically start at the appropriate time. Note: In the Delayed Self-clean Mode, the door latch is automatically activated at the beginning of the cycle. The door lock symbol will appear in the display at this point. The oven lights do not operate in the Self-clean mode. NOTE NOTE If door does not lock, press OFF and do not self-clean; phone 8...