Assessments - 3, GPA: 3
(
)
)
|
Facilidade de uso
...... ... ... ..... ПАНЕЛЬ ИЗ СТЕКЛОКЕРАМИКИ ИНСТРУКЦИИ ПО ЭКСПЛУАТАЦИИ PlYTA CERAMICZNA Instrukcja obslugi VAOIE ZE SKLOKERAMIKY Navod k pou iti PLACA STICLACERAMICA Instructiuni de utilizare Cod. 94000STISPO200 - 3 - Fig.1 Fig.2 Fig.3 Fig.4 A B C Fig.5 - 4 ! !"# !!$%&!$%#&'( )(!*( )+$( )( ),- . )/!$0# !* # *!$ ! !#/##!$ *#!*. &!$10#!$!222/#34!$(* #"#*!$"# !,*#*#!**#&!$$ &!$1!$!$! ENGLISH ENGLISH GENERAL tween the contacts and suited to the load indicated on the plate Carefully read the contents of this leaflet since it provides important instructions regarding safety of installation, use and maintenance. Keep the leaflet for possible future consultation. All the operations relating to installation (electrical connections) must be carried out by specialised personnel in conformity with the regulations in force. SAFETY WARNINGS It is recommended to use flat-bottom pans with a diameter equal to or slightly larger than that of the heated area. Do not use pans with a rough base to prevent scratching the heat surface of the cooktop (Fig.3). This appliance is not suitable for use by children or persons requiring supervision. Do not let children play with the appliance. IMPORTANT -Avoid spilling liquid, therefore to boil or heat liquids, reduce the heat. -Do not leave the heating elements on with empty pots and pans or without receptacles. -When you have finished cooking, switch off the relevant heating element with the control indicated below. WARNING: If the surface is cracked, switch off the appliance to prevent electric shock. INSTALLATION INSTRUCTIONS These instructions address specialised installers and serve as a guide for installation, adjustment and maintenance in conformity with the laws and regulations in force. If a built-in oven or any other appliance that generates heat must be fitted directly under the glass-ceramic cooktop,THIS APPLIANCE (oven) AND THE GLASS-CERAMIC COOKTOP MUST BE SUITABLY INSULATED in such a way that the heat generated by the oven, measured on the bottom right of the cooktop, does not exceed 60°C. Failure to respect this precaution may determine improper functioning of the TOUCHCONTROL system. POSITIONING (Fig.1) The domestic appliance is designed to be built into a worktop as illustrated in the specific figure. Apply sealant around the entire perimeter (cut-out dimensions Fig.1B). Fix the domestic appliance on the worktop by means of the 4 brackets provided, taking the thickness of the worktop into account (Fig.1A). If the lower part of the appliance, after installation, is accessible via the lower part of the cabinet then it is necessary to mount a separator panel respecting the distances indicated (Fig.1C). If the appliance is installed with an oven underneath then the separator is not necessary. ELECTRICAL CONNECTIONS (Fig.2) Before making the electrical connections, check that: -the ground cable is 2 cm longer than the other cables; -the system ratings meet the ratings indicated on the identifica tion plate fixed on the lower part of the worktop; -the system is fitted with efficient earthing compliant to the laws and regulations in force. Earthing is obligatory by law. If the domestic appliance is not fitted with a cable and/or relevant plug, use material suited to the absorption value indicated on the identification plate and the operating temperature. At no point must the cable reach a temperature 50°C higher than room temperature. and conform to the regulations in force (the yellow/green ground conductor must not be interrupted by the switch). When the appliance has been installed, the omnipolar switch must be easily reachable. USE AND MAINTENANCE MAINTENANCE Remove any residues of food and drops of grease from the cooking surface using the special scraper supplied on request (Fig.4) Clean the heated area as thoroughly as possible using SIDOL, STAHLFIX or similar products and a cloth/paper, then rinse with water and dry with a clean cloth. Using the special scraper (optional) immediately remove any fragments of aluminium and plastic material that have unintentionally melted on the heated cooking area or residues of sugar or food with a high sugar content (Fig.4). In this way, any damage to the cooktop surface is prevented. Under no circumstances use abrasive sponges or irritating chemical detergents such as oven sprays or stain removers. USE If your appliance is predisposed then it will be possible to optimize energy consumption via the intelligent handling of the turning on and off of the cooking zones (hotplates). It is possible to set the maximum power absorption to 4 diverse levels: 2.4 KW -3.4 KW -4.4 KW - Pmax. The cook top is factory set with no power limitation (Pmax). · Multi Level Power Control (MLP) In the installation phase, based on the available power in use, it is possible to set the desired maximum power level absorbed in the following way: - Unblock the ...