Log:
Assessments - 0, GPA: 0 ( )

Instruções de Operação Bosch, Modelo HGS7022UC/01

Fabricante : Bosch
Arquivo Tamanho: 1.98 mb
Arquivo Nome :
Língua de Ensino: en
Ir para baixar



por este dispositivo também tem outras instruções :

Facilidade de uso


However, the temperature can be offset if food is consistently too brown or too light. See “Change the Oven Temperature Offset” on page 14. Convection Bake Results are not as expected If the Automatic Convection Conversion Feature is turned off, the temperature must be manually reduced by 25°F. If the feature is active, the temperature is automatically adjusted. See “Turn Automatic Convection Conversion ON or OFF” on page 15 for more information. Refer to cooking charts and tips for rack positions, cooking times and pan selection. Adjust oven calibration if necessary. See “Change the Oven Temperature Offset” on page 14. Oven temperature is too hot or too cold The oven thermostat needs adjustment. See Oven Temperature Offset. Oven light is not working properly Replace or reinsert the light bulb if loose or defective. Touching the bulb with fingers may cause the bulb to burn out. English 39 Service Table 12: Oven Troubleshooting Chart Possible Causes and Oven Problem Suggested Solutions Oven light will not turn off Check for obstruction in oven door. Check to see if hinge is bent. When the Sabbath feature is activated, the oven light will stay on or off (as selected during set-up) during the entire Sabbath mode. Cannot remove lens cover on light There may be soil build-up around the lens cover. Wipe lens cover area with a clean dry towel prior to attempting to remove the lens cover. Oven will not Self-Clean properly Allow the oven to cool before running Self-Clean. Always wipe out loose soils or heavy spillovers before running Self-Clean. If oven is badly soiled, set oven for a five-hour Self-Clean. See Preparing the Oven to Self-Clean. Clock and timer are not working properly Make sure there is electrical power to oven. See Clock and Timer sections. Porcelain chips When oven racks are removed and replaced, always tilt racks upward and do not force them to avoid chipping the porcelain. “F” and a number appears in display and This is a fault code. Press Off to clear the display and stop beeping. Reset control beeps oven if necessary. If fault code remains and beep continues, record fault code, cancel oven and call authorized service technician. With a new range there is a strong odor This is normal with a new range and will disappear after a few uses. Operwhen oven is turned on ating the self-clean cycle will also “burn-off” the smell more quickly. Control does not react when the pad is Be sure that pad is clean. Touch the center of the touchpad. Use the flat touched part of your finger. Fan is not running during a convection On some modes, the convection fan does not come on at the beginning of mode the cycle. This is normal. If the fan is not running at the beginning of the cycle, wait 15 minutes and then check again. If the fan is still not running, call service. Fan turns off and on during the cycle The convection fan turns off while the oven door is open. It resumes when the door is closed again. Fan is running during modes that don’t On some models, the convection fan will run while the oven is preheating use convection for the bake mode. This is normal. Warm air or steam escapes from oven It is normal to see or feel steam or warm air escaping from the oven vent. vent Do not block the vent. How to Obtain Service or Parts To reach a service representative, see the contact information at the front of the manual. Please be prepared with the information printed on your product data plate when calling. Product Data Plate The data plate shows the model and serial number. Refer to the data plate on the appliance when requesting service. It is located on the frame near the drawer. Open the drawer to view it. Data Plate Figure 18: Data Plate English 40 Service Warranty What this Warranty Covers & Who it Applies to: How Long the Warranty Lasts: Repair/Replace as Your Exclusive Remedy: Out of Warranty Product: Warranty Exclusions: The limited warranty provided BSH Home Appliances Bosch in this Statement of Limited Product Warranty applies only to the Bosch freestanding and slide-in range, ("Product") sold to you, the first using purchaser, provided that the Product was purchased: (1) for your normal, household (non-commercial) use, and has in fact at all times only been used for normal household purposes; (2) new at retail (not a display, "as is", or previously returned model), and not for resale, or commercial use; and (3) within the United States or Canada, and has at all times remained within the country of original purchase. The warranties stated herein apply only to the first purchaser of the Product and are not transferable. ·Please make sure to return your registration card; while not necessary to effectuate warranty coverage, it is the best way for Bosch to notify you in the unlikely event of a safety notice or product recall. Bosch warrants that the Product is free from defects in materials and workmanship for a period of three hundred sixty-five days (365) days from the date of purchase. The foregoing tim...

Este manual também é adequado para os modelos :
Placa - HGS7052UC/01 (1.98 mb)
Placa - HGS7052UC/03 (1.98 mb)
Placa - HGS7062UC/01 (1.98 mb)
Placa - HGS7132UC/01 (1.98 mb)

Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias